张小哥

Original God Ruler

Overview

Modified based on the open source project of Lichuang Open Source Platform, adding a protractor, the measuring range of the ruler is 20cm, and the graduation value is 1mm.

Original project: https://oshwhub.com/Lxd15/genshinimpact

Can be modified based on this project

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-07-08 10:55:06

Topics in Introduction to Computer Science?
8. When the address code is a 24-bit binary number, its addressing range is __(MB). Why?
OBDII J1850PWM Issues
[font=宋体]I'm new here, hello to everyone! I'm doing OBDII diagnostic development recently, and I have a few questions to ask experts. Question 1: After connecting to OBDII J1850 PWM, it sends 0X61,6a,
Low level trigger interrupt?
If the setting conditions are as follows:1. The port is set to trigger an interrupt at a low level.2. The interrupt Ena××e bit corresponding to the port = 13. The Ena××e bit of the total interrupt = 1
About launchpad adc12 and dac12
I just got started with launchpad. The g2553 user manual clearly introduces adc12 and dac12, but why is there no interrupt definition for them in g2553.h, only adc10? Are they unusable? ? ? :Cry:
Buy a 430 board to play with, if it's too expensive, don't buy it! (Closed)
I don't have any special requirements, a small board is fine. I don't have an emulator, so it's best if there's an onboard downloader. QQ21305767 [[i] This post was last edited by syaoraner on 2012-9-
How to configure the external clock mode 1 of the STM32 TIM timer
The specific situation is as follows: All configurations are done according to the steps in the instruction manual. The problem is that it can count and trigger the event update interrupt (UIF), but i

Datasheet More

Circuits More