elleny

BioAmp EXG Pill: Professional small, powerful analog front end (AFE) biopotential signal acquisition board (schematic, PCB, software, etc.)

Overview

The BioAmp EXG Pill is a powerful small analog front end (AFE) biopotential signal acquisition board that pairs with any microcontroller unit (MCU) or single board computer (SBC) with an analog-to-digital converter (ADC)) Such as Arduino UNO & Nano, Espressif ESP32, Adafruit QtPy, STM32 Blue Pill, BeagleBone Black and Raspberry Pi Pico, just to name a few. It also works with any dedicated ADC such as Texas Instruments ADS1115 and ADS131M0x etc.

Design Files

BioAmp-EXG-Pill

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-19 05:32:07

Antenna Design Solutions for Next Generation Mobile Devices
Rapid innovation in next-generation mobile devices presents significant engineering challenges in antenna implementation. The key issue is that 5G phones typically have more than twice the RF path of
Plates and cooking pots. What on earth is it? You name it.
This is a set of cooking utensils with a very novel concept. Unlike traditional products, it does not adopt a relatively fixed model, but is designed as independent cooking plates. In fact, it uses th
USBCDC serial port——4 channels at the same time
[md]#####A while ago, I saw a post in the forum [Angry UART HUB]([url=https://bbs.eeworld.com.cn/forum.php?mod=viewthread&tid=521417]https://bbs.eeworld.com.cn/forum.php?mod=viewthread&tid=521417[/url
About the connection between RAM and ROM in quartus2
When I was working on a RISC recently, the control part of the program could be compiled successfully, but when connecting to the external RAM and ROM, the following error would occur: Error: The pin
TI ZStack-CC2530 historical version download
TI ZStack-CC2530 historical version download, here are several versions of CC2530 for your convenience. ZStack-CC2530-2.2.0-1.3.0: [url]http://yunpan.cn/QXHITIiNAxYxQ[/url] ZStack-CC2530-2.3.1-1.4.0:
Nand Flash
I/O 0 I/O 1 I/O 2 I/O 3 I/O 4 I/O 5 I/O 6 I/O 7 1st Cycle A0 A1 A2 A3 A4 A5 A6 A7 2nd Cycle A9 A10 A11 A12 A13 A14 A15 A16 3rd Cycle A17 A18 A19 A20 A21 A22 A23 A24 4th Cycle A25 * * * * * * * NOTE :

Datasheet More

Circuits More