石榴姐

f1c200s_linux

Overview

Original author GloomyGhost

Original link https://oshwhub.com/GloomyGhost/yuzukiruler

Modifications have been made based on the original work to reduce the difficulty of manual welding and benefit novices.

0402 RC is replaced with 0603 RC
EA3036 replaced with SY8088
Add temperature and humidity meter and touch chip
UART1 and UART0 can be selected through resistors to facilitate testing of online firmware
Added TF card holder and nand flash pad
There is no wiring in the main control chip, and the main control chip’s pad is lengthened to facilitate manual welding.

Not yet verified! ! !

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-19 19:27:06

Confusion of beginners of 430
When set as IO port output, it can be read and written. What does it mean to be readable when in output? Why can't I generate a square wave by writing P1DIR |=0xff P1OUT|=BIT1; delay(50000); P1OUT&=~B
Working principle of simple protection circuit for open LED fault
[i=s]This post was last edited by dontium on 2015-1-23 13:31[/i] [b][font=宋体][size=12pt]Keywords: power management,[/size][/font][/b][b]LED[/b][b][font=宋体][size=12pt], lighting, Texas Instruments,[/si
How to implement a phase-locked loop
I am doing a simulation experiment of a converter station. I need to transform the collected three-phase grid voltage into a dq rotating coordinate system. Therefore, a phase-locked loop is needed to
51+12864+ infrared remote control to play Snake and Tetris
The game console is made of ST C89C52+12864+infrared remote control. There are two games, Snake and Tetris. The MCU storage space is not enough, so no optimization is done after the program runs norma
Show the process of WEBENCH design + FPGA circuit design
Using WH to design an Altara FPGA, there is also a detailed power supply circuit design in the design. The specific steps are shown in the figure:
Design of anti-theft monitor based on GSM module
[align=left][font=宋体][size=14px][font=Verdana][color=#000000][b]The new anti-theft monitoring system relies on the GSM public network, uses short message value-added services, uses MSP430 single-chip

Datasheet More

Circuits More