念慈菴

USB2.0 hub【1to4】

Overview

The USB2.0 hub based on FE1.1S can expand 4 USB peripherals at the same time. The schematic diagram comes from Lichuang EDA teaching activities

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-23 13:06:25

In this case, is it better to install a reducer or not?
There is a device that uses a servo motor to drive the screw to drive the platform to do reciprocating motion. It is calculated that to achieve the highest movement speed of the platform, the speed of
Ask about self-built database
I want to encapsulate the key algorithms so that they can be executed in RAM. I also want to encapsulate some instructions for operating the lotus and peripherals. I think the location may need to be
Simple wireless microphone
If your radio has an FM receiving band, you might as well make a wireless microphone to add a lot of fun to your life. Here is a wireless microphone with an effective distance of about 100 meters in a
[STM32 IIC+24LC512] Parameter reading, writing and storage issues
[color=rgb(51,51,51)][backcolor=rgb(255,255,255)][size=5]As the title says: Use the IIC interface of STM32 to control the reading and writing of 24LC512. The parameters can be written into the chip no
Questions about using Keil software
[i=s] This post was last edited by paulhyde on 2014-9-15 03:13 [/i] My keil software can find the STC51 series model when I start to build a project. However, after using the keil software to build a
51 MCU learning experience and 51 MCU pull-up resistor experience
[align=left]1. The P0 port of 51 single-chip microcomputer is very special. 2. The operation of 51 single-chip microcomputer is essentially the operation of registers, and the same is true for other s

Datasheet More

Circuits More