JiYv619jod

PCF8574

Overview

The IO of esp8266 is scarce, and it can expand multiple IOs through two pins and I2C protocol to achieve more functions.

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-07-07 08:02:30

When driving VS1003, both XCS and XDCS must be pulled down. If only XDCS is turned on, the music cannot be played? ?
After converting the VS1003 driver code from 51 to arm7, I encountered two problems: 1) Both XCS and XDCS must be pulled low. If only XDCS is pulled low, the music cannot be played? ? 2) When a comple
Understanding the ENOB formula for ADC converters
[i=s] This post was last edited by dontium on 2015-1-23 11:44 [/i] Understanding the ENOB formula of ADC converters
How to route the positive and negative lines of LEDs on a PCB
How to route the positive and negative lines of the LED on the PCB, with the smallest loop and the best anti-interference ability? What is the most appropriate route? Does the master have any relevant
I am just getting started with Verilog, please give me some pointers
As the title says, please give me some advice. Even if it's just a few words, I will be grateful here.
AT89S51 ISP programmer problem
I downloaded an AT89S51 ISP burner circuit diagram and an online programmer from the Internet. The programmer and the circuit diagram are packaged together. However, after soldering the circuit, I con
Electronic Competition K Question
One reply said that the power metering chip cannot be used. Why? The second question is to make a recognizable minimum current appliance with resistors. Can you give me some ideas?

Datasheet More

Circuits More