石榴姐

NCP10970BGEVB: NCP10970B Evaluation Board

NCP10970BGEVB: NCP10970B evaluation board

Overview

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-25 23:45:34

Simple Questions
After decompressing the wince image, are all the contents resident in the memory? To update the registry and database, it is necessary to read and write the flash, right? But when writing back to the
EEWORLD University Hall--Introduction to LPCOpen software platform and its use
Introduction to LPCOpen software platform and its usage : https://training.eeworld.com.cn/course/597
lm3s8962 driver codec chip plays mp3
Actually, I have already written an application... But a senior said that the file system and SD card read and write implementation are too wasteful for 8962... I would like to ask you a question, can
MSP430 driving 74HC595
Use MSP430 to drive 74HC595. Below is the main program. P2.0 is serial data input, P2.1 is RCK, and P2.2 is SCK. Assuming the serial input is 01010101, why can't I measure the voltage on the parallel
The internal crystal oscillator of STM32F103ZE cannot be used?
The ST3210E-LK development board is used for the test. The development environment is EWARM 5.0. There is no problem with the program started by the external crystal oscillator, but it cannot be used
12-bit Analog Monitoring and Control Solution
With multi-channel analog-to-digital converter (ADC), digital-to-analog converter (DAC) and temperature sensor ApplicationsRadio frequency (RF) power amplifier control in base stationsTest and measure

Datasheet More

Circuits More