elleny

NCP59152MNADGEVB: 1.5 A Adjustable VLDO Regulator Evaluation Board

Overview

The NCP59152 is a high precision, very low dropout, low ground current voltage regulator. The device is capable of providing an output of 1.5 A with a typical dropout voltage lower than 300 mV at full load. The NCP59152 features internal protections of output current limiting, built-in thermal shutdown and reverse output current while withstanding up to 18 V max input voltage. This device is available in D2PAK-5 and DFN8 packages.

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-05-11 14:46:58

How do I change the ADC12 register if I want to measure an external voltage?
void adc_clkinit() { ADC12MCTL0=ADC12SREF_1+ADC12INCH0; ADC12CTL0 =ADC12ON+ADC12SHT0_2+ADC12REFON+ADC12REF2_5V; //ON: AD work enable SHT0_2: conversion time ADC12CTL1 =ADC12SHP; //When SHP=1, ADC12SC=
Does MW5 have to use TI's communication module? If I use Wavecom's communication module, how should I process RIL?
Does mw5 have to use TI's communication module? If I use wavecom's communication module, how should I handle ril? Even if you can give me an idea, thank you.
【MicroPython】+ Radio-controlled clock (Part 2: LCD)
[i=s]This post was last edited by jameswoo on 2016-6-16 00:06[/i] I have finally finished debugging the LCD display. I wrote a library program to use the MicroPython Pin port to simulate the writing s
How to design a larger single-chip microcomputer system? Urgent!
Hey guys, I just started working not long ago, and my knowledge of single-chip microcomputer is limited to the knowledge in books, and I have no practical experience at all. Now I have encountered a d
Talking about software specifications from 51 to 430
Previously, I used 51 single-chip microcomputers, which are very convenient for writing small programs. However, when the total program volume of the project increased to 5K, I was confused by the for
Selection of capacitors for power supply
Capacitors are one of the most critical passive components for achieving a wide range of voltage and current combinations in power supplies. Although every capacitor can store electrical energy, the d

Datasheet More

Circuits More