Bp8aG

balance car

Overview

Can stand upright and balance, Bluetooth remote control, remote parameter adjustment, pick up and put down detection and other functions

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-07-03 02:05:26

About the status of the pull-up and pull-down resistors inside the MSP430
When the MSP430 microcontroller IO port is used to detect high and low levels, no external pull-up or pull-down is required because it has internal pull-up and pull-down.When used as high or low level
How NEC's chips drive DC motors
[i=s]This post was last edited by paulhyde on 2014-9-15 09:27[/i] The control mode of the chip driving the stepper motor is more flexible, but for driving the DC motor, the only thing that can be chan
Emergency lighting solution
[[i]This post was last edited by jxb01033016 on 2010-8-18 09:38[/i]]
Channel Estimation & Equalization for WiMAX
Introduction The Altera channel estimation and equalization modules for mobile worldwide interoperability for microwave access (WiMAX) can be used to accelerate the development of mobile broadband wir
boot settings
My chip is STM32F103c6t6a. How do I set boot0=1 boot1=0? I use STMISP to burnThe instructions for this software are to set boot0=1 boot1=0 first. How do I set it? Thank you [[i ] This post was last ed
Win a JD.com card! Check in at Infineon's new SiC MOSFET pop-up store
Event time: From now until July 24Event process:1. Click the "Check-in now" button below to enter the pop-up store and start the event;2. Click on the 4 check-in points in the pop-up store, follow the

Datasheet More

Circuits More