JFET

STC8G expansion board_WS2812 lighting expansion module

Overview

The project is part of the STC8G expansion board series: WS2812B_lighting expansion module, which is used to learn the main control of STCG81K08A and the use of WS2812B.
The expansion board is connected to the main control through a cable, and its definition is as follows:

As shown in the figure, the WS2812B lamp set is connected to the P5.5 pin of STC8G and uses 5V power supply.

The expansion board also leads to 3.3V and 5V binding posts for use.

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-23 02:09:49

WINCE screen scrolling
The screen of the customized WINCE system rolls over. I have never encountered this problem before. I don't know why. This problem did not occur when I used this BSP to compile before. This problem oc
Let's discuss what is needed to DIY a remote control for a model airplane
I need help! I am a beginner and want to DIY a six-channel wireless remote control. For this purpose, I bought a 51 learning board (almost catching up with the price of a remote control). I mainly wan
4G SD card boot recognition problem ~ Sometimes the drive letter can be displayed, sometimes it cannot be displayed.
The platform pxa270+wince6.0 shows that the 4G SD card is used. There is a strange recognition problem. Sometimes the drive letter can be displayed when the computer is turned on, and sometimes it can
Design of Elevator Controller Based on FPGA
design
Help: Power supply problem of full-bridge drive circuit
For the driver IC that controls the upper bridge arm, the negative pole of the power supply is connected to VEE. It is said that the optocouplers that drive the upper and lower bridge arms cannot be p
Music reminder timer design
The music reminder timer is designed with 4 buttons to set the desired countdown time: K1--the countdown time can be adjusted from 1 to 60 minutes; K2-set the countdown time to 5 minutes, displayed as

Datasheet More

Circuits More