supremeOne

RDR-710 - 12 W dual output open frame power supply for devices using InnoSwitch3-TN

RDR-710 - 12 W Dual Output Open Frame Power Supply for Appliances Using InnoSwitch3-TN

Overview

12 W dual output open device power supply using InnoSwitch3-TN (INN3074M) Output: 5V, 1.4A; 12V, 0.42A Input: 85 - 265 VAC Built-in synchronous rectification, >85% efficiency at nominal AC input Typical no-load input Power <10 mW Standby input power at 5 V/30 mA load <260 mW12 W dual output open frame appliances power supply using InnoSwitch3-TN (INN3074M)Output: 5 V, 1.4 A; 12 V, 0.42 AInput: 85 - 265 VACBuilt in synchronous rectification for >85% efficiency at nominal AC input<10 mW typical no-load input power typically<260 mW standby input power at 5 V / 30 mA load

Blockdiagram

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-01 19:42:03

Understanding Analog Circuits: Active Devices
[i=s]This post was last edited by dontium on 2015-1-23 12:42[/i] This is also from TI. The article talks about the characteristics of several active devices: transistors, JFETs, MOSFETs, op amps, comp
Please give me some advice.
I am about to start a hydrological project. Specifically, I am going to make an RTU device that can collect information such as rainfall and water level, and then send it to the monitoring center via
STM32 low power library upower
For various reasons, micropython has not been optimized much in terms of low power consumption, resulting in high power consumption and failure to give full play to the low power performance of the ch
Looking for a single-chip minimum system schematic and PCB diagram
In order to complete my homework, I need to design a single-chip minimum system. I want to find a reference. Does anyone have one? If you can share it, I'd be very grateful!
AD20 PCB copper plating PR, the copper plating is filled before it is closed. How to set it to not be filled before it is closed and displayed in dotted line form?
AD20 PCB copper plating PR, the copper plating is filled before it is closed. How to set it to not be filled before it is closed and displayed in dotted line form? Do not fill before closingAD20 is fi
Please explain this hardware circuit~~~~~
original:Since the wheelchair controller uses bipolar mode, there are four power tubes: T1 , T2 , T3 , T4 , among which the PWM pulse signals of T1 and T4 are the same, the PWM pulses of T2 and T3 are

Datasheet More

Circuits More