Introduction: 11111111111111111111111111111111111111
Introduction: 67W Small Portable PCB Heating Station
Introduction: Everyone has been working on a heating table recently to make it easier to solder boards. I also made a small control board with the things I had on hand. I did not use PID control. It may be added later.
Introduction: Imitation microphase FPGA development board
Introduction: This project is the STM32G030CBT6 minimum system.
Introduction: A USB switch made using CH440+51 microcontroller. KVM does not have V. You can connect a USB device to one of the two hosts and use the button to switch the host.
Introduction: Read the piezoresistive sensor signal, amplify it, and communicate using Bluetooth
Introduction: This is a project to automatically wind the electronic rotor. The microcontroller solution is arduino mega2560. The motor drive solution is Toshiba's TB6600, and the alternative solution is Trinamic's MTC2160.
Introduction: Wildfire F429 minimum system backplane expansion board
IO rearranged in order
Introduction: A simplified version of Vllink Lite, retaining SWD and UART functions and reducing the PCB area. Using GD32F350G8U6 solution
Introduction: DAPLink debugger, using USB-C interface, leading out SWD, UART, SWO and MCO pins
Introduction: Use CH224K to simulate fast charging protocol and use the charging head to output multi-level voltage. With output switching function, the output is turned off by default when power is turned on to prevent direct output of high voltage from damaging the equipment.
Introduction: Serial port download and debugging probe module, with TX and RX switching switches, probe pitch 2.54mm