R_156_V10 Design based on IPS2 motor commutation sensor

Schematic PCB

RDR-506 - 1.44 W non-isolated buck converter using LinkSwitch-TN2

Schematic PCB

R_59_V10 Design based on IPS2 motor commutation sensor

Schematic PCB

R_151_V10 Design based on IPS2 motor commutation sensor

Schematic PCB

DER-427 - 33W dimmable LED driver for T8 tubes

Schematic PCB

R_68_V10 Design based on IPS2 motor commutation sensor

Schematic PCB

DER-515 - 12 W non-dimmable non-isolated LED driver

Schematic PCB

R_85_V10 design based on IPS2 motor commutation sensor

Schematic PCB

R_71_V10 Design based on IPS2 motor commutation sensor

Schematic PCB

R_72_V10 Design based on IPS2 motor commutation sensor

Schematic PCB

DER-660 - 29 W high power factor, isolated flyback LED driver with DALI dimming

Schematic PCB

R_93_V10 Design based on IPS2 motor commutation sensor

Schematic PCB

DER-409 - 8.5 W PFC TRIAC dimmable non-isolated buck-boost LED driver for A19 lamps

Schematic PCB

Sunmachine-A2 - Intelligent Lighting System

Driver for WS2812, SK6812 or similar LED strips controlled via Bluetooth LE. It supports RGB and WWA LEDs. The drive uses motion and light sensors so in automatic mode it can turn on the lights when it detects the presence of someone in the dark.

Schematic PCB

DER-637 - 35 W High Power Factor, Isolated Flyback Switched Valley-Fill PFC LED Driver

Schematic PCB

R_56_V10 Design based on IPS2 motor commutation sensor

Schematic PCB

DER-396 - 20 W high efficiency (>86%), triac dimmable, isolated flyback LED driver with power factor correction designed using LYTSwitch-4

Schematic PCB

thermostat

5.1W non-dimmable, high power factor, non-isolated step-down LED driver designed using LYTSwitch-0 LYT0006D

This document introduces a highly compact and cost-effective step-down power supply designed using the LYTSwitch-0 series device (LYT0006D).
The power supply can operate from an input voltage range of 90 to 132 VAC. The DC bus voltage is high enough to support a 38 V output when using a buck topology. In a buck converter, the output voltage must always be lower than the input voltage. In addition, the output voltage is also limited by the maximum duty cycle of LYTSwitch-0, which also requires that the input voltage must be higher than the output voltage.

Schematic PCB

DER-412 - 12 W high power factor, non-isolated, buck-boost, triac dimmable LED driver

Schematic PCB