STEVAL-CCA012V1
3 W filter-free class-D audio amplifier demonstration board with
6-12 dB fixed gain select based on the TS2007
Data brief
Features
■
Operating range from V
CC
= 2.4 V to 5.5 V
■
Dedicated standby mode active low for each
channel
■
■
■
■
■
■
■
■
■
■
■
■
Output power per channel: 1.4 W @ 5 V or 0.5
W @ 3.0 V into 8
Ω
with 1% THD+N max
Output power per channel: 2.3 W @ 5 V or 0.75
W @ 3.0 V into 4
Ω
with 1% THD+N max
Two fixed gain selects: 6 dB or 12 dB
Low current consumption
Efficiency: 88% (typ)
Signal-to-noise ratio: 90 dB (typ)
PSRR: 68 dB (typ) @ 217 Hz with 6 dB gain
PWM base frequency: 280 kHz
Low pop and click noise
Thermal shutdown protection
Output short-circuit protection
RoHS compliant
Description
O
The STEVAL-CCA012V1 demonstration board is
based on the TS2007FC audio power class-D
amplifier, housed in a Flip-Chip package, which is
capable of driving up to 1.4 W into an 8
Ω
load at
5 V. The device offers improved efficiency
compared to typical class-AB audio amplifiers.
The TS2007FC allows switching between two
different gains: 6 or 12 dB via a logic signal on the
GS pin. Pop and click reduction circuitry provides
low on/off switching noise while allowing the
device to start within 1 ms. An active low standby
function permits lower current consumption (down
to 1 µA typ). The TS2007FC also integrates
output short-circuit protection and thermal
shutdown protection.
The STEVAL-CCA012V demonstration board is
constructed on a two-layer PCB with easily
accessible connectors, allowing users to change
June 2009
Doc ID 15861 Rev 1
1/4
www.st.com
4
et
l
so
b
ro
P
e
u
d
)-
(s
ct
b
O
or drive the gain select and standby control pin,
and to change the input configuration.
so
t
le
ro
P
e
uc
d
s)
t(
STEVAL-CCA012V1
AM03155
For further information contact your local STMicroelectronics sales office.
STEVAL-CCA012V1
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any
time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any
liability of ST.
O
et
l
so
b
ro
P
e
u
d
s)
t(
c
O
-
so
b
t
le
ro
P
e
uc
d
s)
t(
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2009 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com
4/4
Doc ID 15861 Rev 1
Electronics Design Contest
京公网安备 11010802033920号
EEWORLD
