In the Wi-Fi table, it mentions the frequency of the router/gateway, either 2.4 GHz or 5 GHz. It is recommended that an apartment or condo type housing setup should be 5 GHz to avoid any possible inte...
A post about the abnormality of the DM648 network port. The final reason is that the JTAG TCLK is not pulled down. The following is part of the original post:We've been having problems with Ethernet c...
An electronic accelerator is not an electronic throttle accelerator for cars. This electronic accelerator is a new product and new technology. Traditional cars can solve the following problems by conn...
[font=宋体]Yuan Fang: Sir, last time you pointed out the zero-pole distribution in the case, and the various elements of the case have been revealed, but Yuan Fang still cannot sort out the whole case f...
Engineers who are new to wireless design and wireless product development need to master the basics of
RF measurement
. In many cases, this process is to enable engineers who have been engag...[Details]
The small size and low cost of home appliance control boards mean that high-cost materials will not be used in the circuit to solve the electromagnetic interference problem. The interference of hom...[Details]
1 Introduction
The intelligent meter reading system is a system that reads the data of multiple user meters in a centralized manner through the transmission media by the master station. It...[Details]
Multiple Input and Multiple Output (MIMO) technology is arguably the next most important development in wireless communications since the advent of digital communications. Many new wireless commun...[Details]
Semiconductor devices used in high-end computing (advanced microprocessors) and consumer electronics (graphics and gaming chipsets) devices generally provide data rates up to 6.4Gbps through hig...[Details]
Most
embedded
systems are powered from a 48V backplane. This voltage is typically stepped down to a lower intermediate bus voltage of 24V, 12V, or 5V to power the circuit board racks withi...[Details]
Abstract This paper
introduces a wireless radio frequency transmission chip nRF9E5 based on 8051 core. The remote control system of flapping-wing micro-aircraft is made by using this chip. Th...[Details]
Abstract:
This paper introduces the excitation system designed for 3/3 phase double winding induction generator, which is composed of DSP and FPGA. The interface circuit of the control sys...[Details]
Abstract: This paper introduces the controller, interface, display principle and driving method of the handheld computer LCD display based on the SA1110 microprocessor. Combined with the HPC projec...[Details]
Billboards are information display terminals for the public, with a wide range of civil and commercial values. However, most of the information displayed on billboards is currently solidified in th...[Details]
This paper introduces the technology and application of optical transceiver modules and digital non-volatile variable resistors in optical communication networks, and focuses on the design and appl...[Details]
IntroductionUSB
, serial port, and parallel port are commonly used interfaces for communication between PC and peripherals. However, for images with large data volumes, if the serial RS-232 protoc...[Details]
Preface
Sine wave inverters are widely used in various fields such as electricity, post and telecommunications, communications, and aerospace. Moreover, with the continuous development and...[Details]
1. Introduction
Most of the existing heaters use traditional devices such as electric heating tubes and electric heating wires for heating. The outer shell of the electric heating tube is a ...[Details]
Development Status
Looking at the development of security monitoring technology: from the first generation of analog monitoring, to the second generation of digital monitoring, and then up...[Details]