Power supply. Connect both pins to same voltage (either 3.3 V or 5 V).
Connect to ground.
Select input 0. See table above.
Select input 1. See table above.
Clock Output 7. See table above.
Clock Output 8. See table above. Normally use this clock as feedback.
Feedback Input. Connect to CLK8 under normal operations.
Key: I = Input; O = output; P = power supply connection.
External Components
The ICS671-01 requires a minimum number of external components for proper operation. Decoupling
capacitors of 0.01µF should be connected between VDD and GND on pins 4 and 5, and VDD and GND
on pins 13 and 12, as close to the device as possible. A series termination resistor of 33
Ω
may be used close
to each clock output pin to reduce reflections.
2
Revision 051700
Printed 11/15/00
Integrated Circuit Systems, Inc.• 525 Race Street • San Jose •CA•95126• (408) 295-9800 tel • www.icst.com
MDS 671-01 B
ICS671-01
Zero Delay, Low Skew Buffer and Multipler
Electrical Specifications
Parameter
Supply voltage, VDD
Inputs and Clock Outputs
Electrostatic Discharge
Ambient Operating Temperature
Soldering Temperature
Junction temperature
Storage temperature
Operating Voltage, VDD
Input High Voltage, VIH, CLKIN pin only
Input Low Voltage, VIL, CLKIN pin only
Input High Voltage, VIH
Input Low Voltage, VIL
Output High Voltage, VOH
Output Low Voltage, VOL
Output High Voltage, VOH, CMOS level
Operating Suppl Current, IDD (Note 2)
Operating Suppl Current, IDD (Note 3)
Short Circuit Current
Input Capacitance
Conditions
Referenced to GND
Referenced to GND
MIL-STD-883
Max of 10 seconds
-65
3.13
VDD/2+1
2
0.8
IOH=-25mA
IOL=25mA
IOH=-8mA
No Load, S1=1, S0=0
No Load, S1=1, S0=0
Each output
S0, S1, FBIN
2.4
0.4
VDD-0.4
25
74
±50
7
Minimum
-0.5
-0.5
2000
0
Typical
Maximum
7
VDD+0.5
70
260
150
150
5.50
VDD/2
VDD/2
VDD/2-1
Units
V
V
V
°C
°C
°C
°C
V
V
V
V
V
V
V
V
mA
mA
mA
pF
ABSOLUTE MAXIMUM RATINGS (note 1)
n
DC CHARACTERISTICS (VDD = 3.3 V unless specified otherwise)
t
AC CHARACTERISTICS (VDD = 3.3 V unless specified otherwise)
h
Input Clock Frequency
See table on page 2
5
80
MHz
Output Clock Frequency
See table on page 2
5
160
MHz
Output Clock Rise Time, CL=30pF
0.8 to 2.0V
1.5
ns
Output Clock Fall Time, CL=30pF
2.0 to 0.8V
1.5
ns
Output Clock Duty Cycle, VDD=3.3V
At VDD/2
40
50
60
%
Device to Device Skew, equally loaded
rising edges at VDD/2
700
ps
Output to Output Skew, equally loaded
rising edges at VDD/2
250
ps
Input to Output Skew, FBIN to CLK8
rising edges at VDD/2
±350
ps
Maximum Absolute Jitter
300
ps
Cycle to Cycle Jitter, 30pF loads
500
ps
Notes: 1. Stresses beyond those listed under Absolute Maximum Ratings could cause permanent damage to the device. Prolonged
exposure to levels above the operating limits but below the Absolute Maximums may affect device reliability.
2. With CLKIN = 20 MHz, FBIN to CLK8, all outputs at 40 MHz.
3. With CLKIN = 80 MHz, FBIN to CLK8, all outputs at 160 MHz.
3
Revision 051700
Printed 11/15/00
Integrated Circuit Systems, Inc.• 525 Race Street • San Jose •CA•95126• (408) 295-9800 tel • www.icst.com
MDS 671-01 B
ICS671-01
Zero Delay, Low Skew Buffer and Multipler
Package Outline and Package Dimensions
(
For current dimensional specifications, see JEDEC Publication No. 95.)
16 pin SOIC narrow
Symbol
A
A1
E
INDEX
AREA
H
B
C
1
2
D
A1
e
Ordering Information
Part/Order Number
ICS671M-01
ICS671M-01T
h x 45°
A
L
D
E
e
H
h
L
Inches
h
Min
Max
0.0532
0.0688
0.0040
0.0098
0.0130
0.0200
0.0075
0.0098
0.3859
0.3937
0.1497
0.1574
.050 BSC
S
0.2284
0.2440
0.0099
0.0195
0.0160 0.0500
Millimeters
m
Min
Max
1.35
1.75
0.10
0.24
0.33
0.51
0.19
0.24
9.80
10.00
3.80
4.00
1.27 BSC
S
5.80
6.20
0.25
0.50
0.41
1.27
B
C
Marking
ICS671M-01
ICS671M-01
Shipping packaging
tubes
tape and reel
Package
16 pin SOIC
16 pin SOIC
Temperature
0-70 °C
0-70 °C
While the information presented herein has been checked for both accuracy and reliability, Integrated Circuit Systems, Incorporated (ICS) assumes no responsibility for either its
use or for the infringement of any patents or other rights of third parties, which would result from its use. No other circuits, patents, or licenses are implied. This product is
intended for use in normal commercial applications. Any other applications such as those requiring extended temperature range, high reliability, or other extraordinary
environmental requirements are not recommended without additional processing by ICS. ICS reserves the right to change any circuitry or specifications without notice. ICS does
not authorize or warrant any ICS product for use in life support devices or critical medical instruments.
4
Revision 051700
Printed 11/15/00
Integrated Circuit Systems, Inc.• 525 Race Street • San Jose •CA•95126• (408) 295-9800 tel • www.icst.com
The list is out and can be seen here: https://bbs.eeworld.com.cn/thread-1084541-1-1.html
Welcome everyone to guess the questions: https://bbs.eeworld.com.cn/thread-1084544-1-1.htmlGuan Zai looked at t...
I also found a copy online, but it's too blurry. Does anyone have clear Chinese information about 8155? I hope you can share it. The website is in a foreign language, and I can't understand it at my c...
I will never come to the power management LED forum again... It's so annoying... The content is hidden, but the replies are visible... It's fine if the content is good, but it's also hidden if it's no...
Program: void Timer0_ISQ(){ TimerIntClear(TIMER0_BASE,TIMER_A); time_10ms++; if (time_10ms==1){ I2CMasterSingleTRANSMIT(I2C9_BASE,ALT_Adress,0x48);//The first step is to send the conversion instructio...
Abstract: This paper introduces a satellite broadband access system , analyzes the data format of broadband multimedia signals transmitted by the satellite broadband access system, and discusses the f...
1 Introduction
A wide variety of communication cables and control cables are widely used in various instruments and control equipment. Whether the cable is well-conducted and
whether
th...[Details]
Google's driverless technology is not only an eye-catching technology, but also a subversion of the car usage model.
Those who have watched anti-terrorism films and TV dramas must have been im...[Details]
Due to the significant increase in electronic devices in automotive and industrial applications, the automotive and industrial markets continue to play an important role in China's electronics in...[Details]
In recent years, lighting has become an important area that countries around the world are targeting to promote energy conservation and environmental protection. According to statistics, about 20% ...[Details]
We know that microcontroller development tools generally include real-time online emulators and programmers. Among them, online emulators are very good tools, but they are also more expensive...[Details]
From the PIC16F946 datasheet, we know that there are two ways to write values to the LCD for display:
1. Directly write the value to LCDDATA1~LCDDATA23
2. Use disconnect t...[Details]
Overview
As a remote network communication control method with advanced technology, high reliability, complete functions and reasonable cost, CAN-bus has been widely used in various automa...[Details]
MediaTek (2454) announced the acquisition of F-MStar (3697) and attracted the attention of IC design industry. This morning, Gartner Semiconductor Industry Research Director Hong Cenwei analyzed ...[Details]
In recent years, with the rapid development of the information industry, dot matrix LED display screens have been widely used in various advertising and information display systems such as the fina...[Details]
Problems such as the depletion of natural resources, air pollution, traffic congestion, and rising fossil fuel prices have forced societies and individuals to seek alternative means of transportati...[Details]
Motors, especially those with brushes, generate a lot of noise. This noise must be dealt with if the appliance is to meet the requirements of EMC standards. The means to solve EMC are nothing more ...[Details]
Today, the value of electronic components in cars accounts for 15-20% of the total vehicle. In the future, this proportion may be as high as 30-40% as more safety electronics, fuel consumption and ...[Details]
Abstract: The output of high-range acceleration sensor is less than 10 mV under the excitation of small signal. The noise of traditional test system may cover such small voltage signal, so that hig...[Details]
Introduction
X1226 has the functions of clock and calendar. The clock relies on hour, minute and second registers to track, and the calendar relies on date, week, month and year registers to tr...[Details]
With the rapid development of wireless
digital communication
, more challenges have been raised for integrated circuit design and testing. In the product design stage, in order to ensure
t...[Details]