I just deduced the schematic diagram of a 5-port Ethernet switch based on the actual device. The main chip is DM9081. It is in PROTEL99SE format. [[i] This post was last edited by Simon on 2009-5-12 1...
Interrupts are a major feature of the MSP430 microprocessor. Effective use of interrupts can simplify programs and improve execution efficiency.
MS430 has many interrupts, and almost every peripheral ...
When debugging the 5509A program, I found that I could not connect to the emulator, but I could do it by changing the board. It took me a while to solve this problem. I recorded the test process and s...
:) It's my first time to use STM32, and there are so many registers that I feel overwhelmed. Today, I was bored, so I sorted out the RCC register group, which has 10 registers in total. Although I did...
Hello everyone: I used the AD633 multiplier to make an analog phase-detection circuit, multiplying the two sine waves X and Y, and getting the following oscilloscope waveform at the OUT end. The outpu...
Emergency hand-held lamps powered by 6V maintenance-free batteries are widely used in rural areas. The charger used is a transformer step-down and single diode half-wave rectifier, and the charging...[Details]
1. Introduction to CIF Board
Fieldbus integration based on PC system
Whether it is a master or a slave, fieldbus has won unanimous praise in the field of PC-based automation. For more...[Details]
The rectified DC voltage is then converted back to AC using power electronics such as insulated gate bipolar transistors.
The output voltage is switched on and off at a high frequency, control...[Details]
Portable power applications are broad and varied. Products range from wireless sensor nodes with average power consumption of only a few microwatts to in-vehicle medical or data acquisition systems...[Details]
0 Introduction
In the design and construction of communication systems,
communication power supply
is called the heart of the communication system. The power supply system will dire...[Details]
TMC428 is a stepper motor motion controller from TRINAMIC. It can reduce the workload of motor control software design and development costs. The 3-axis stepper motor drive control system based on ...[Details]
UDN2916LB is a two-phase stepper motor bipolar driver integrated circuit launched by SANKEN. It can drive dual-winding bipolar stepper motors and is particularly suitable for controlling dual-step ...[Details]
Stepper motors, also called steppers, use the principles of electromagnetism to convert electrical energy into mechanical energy and have been used since the 1920s. With the increasing popularity o...[Details]
1 Causes of problems with electric vehicle batteries
1.1 Caused by the battery itself
Why do we say that? In the previous issue, we learned about the working princi...[Details]
Lithium iron phosphate batteries are used as lithium-ion secondary batteries. Their main application is now in power batteries, which have great advantages over NI-H and Ni-Cd batteries.
Lithi...[Details]
With the continuous development of integrated circuit technology, integrated circuits have developed from thousands of gates to the current level of millions and tens of millions of gates. The applica...[Details]
1. Electromagnetic compatibility design
Electromagnetic compatibility refers to the ability of electronic equipment to work in a coordinated and effective manner in various electromagnetic env...[Details]
Modern communication equipment, portable electronic products, laptops, electric vehicles, small satellites, etc. generally use batteries as power sources and are widely used. However, the batteries...[Details]
1 Introduction
The early stage control system used relay control. Due to the large number of stage equipment, the number of control elements is huge and the wiring is complicated. Therefore, th...[Details]
1. Introduction
Due to the good programmability and superior performance of FPGA, the number of embedded systems using FPGA chips in LCD splicing screens is increasing rapidly, especially in t...[Details]