It takes 8-10 hours to charge a car, which is tantamount to treating the charging station as a parking lot. So we can think about it in another direction: Can the parking lot also be used as a chargin...
I want to make a button for long pressing to shut down the system in WinCE5.0. The hardware is connected to the interrupt, but I don't know how to handle it in software. If it is just a simple stream ...
ABB550 series inverter, the motor is 37KW made by a small factory (not a variable frequency motor). The interference cannot be removed. The inverter has a separate power distribution cabinet, and the ...
I used the three-wire mode. After the host was running, the SCK corner had not been output. I used the UTR0 and SPI0 of 360. So when designing the pins, I skipped P0.1, P0.2, and P0.3 as a test port. ...
I found that this reset circuit can download the program, but it cannot be started. After pulling up a 10K resistor on NRST_MCU, it can work normally. Can you please discuss why this is? Thank you!...
The program was originally compiled under QT and ported here. The normal code under QT is as follows: #define OUTPUT_DEBUG_INFO //Input debugging information to the terminal #ifdef OUTPUT_DEBUG_INFO #...
Today's computer peripherals are pursuing high speed and high versatility. In order to meet user needs, seven companies led by Intel launched the USB (Universal Serial Bus) bus protocol in 1994, wh...[Details]
This program is written to simulate the serial port hardware mechanism. When used, a timed interrupt can be set with a time interval of 1/4 baud rate. The receiving function is called once for ea...[Details]
1. Introduction
RFID (radio frequency identification) is a non-contact automatic identification technology that emerged in the 1990s. It uses the characteristics of radio frequency signal prop...[Details]
As a wireless broadband metropolitan area network standard, WiMAX technology has greater advantages than previous 3.5GHz MMDS products in terms of non-line-of-sight transmission and spectrum utiliz...[Details]
Analog engineers have traditionally struggled with complexity when designing power supplies that required multiple outputs, dynamic load sharing, hot-swap, or extensive fault-handling capabilities....[Details]
introduction
In the discharge process of tokamak plasma physics, the study of rupture and sawtooth is of great significance. Rupture and sawtooth exist in most tokamaks. Rupture is a notew...[Details]
The Mobile Industry Processor Interface (MIPI) Alliance is an organization responsible for promoting the standardization of software and hardware in mobile devices. It has released the D-PHY specif...[Details]
The reason for the light decay of white LEDs: the decline of phosphor performance
So far, the rapid decline of the luminous performance of white light LEDs, especially low-power white light LE...[Details]
DSP (digital signal processor) is used more and more frequently in today's engineering applications. There are three main reasons for this: first, it has powerful computing power and is capable of ...[Details]
Electronic systems are located at different points on the automotive power bus and therefore often need to operate under very stringent power requirements. These include load dump, cold crank, very lo...[Details]
The solidification and modularization of intelligent video analysis algorithms are the current trends in the application of intelligent video analysis technology. It perfectly combines intelligent ...[Details]
1 Introduction
Ultrasonic waves have strong directivity, slow energy consumption, and can propagate over long distances in a medium, so they are used for distance measurement. Ultrasonic detec...[Details]
We know that microcontroller development tools generally include real-time online emulators and programmers. Among them, online emulators are very good tools, but they are also more expensive...[Details]
A multi-point temperature control heating control system was designed using the SST89E564RC single-chip microcomputer and a new temperature measuring device. The heating system can be controlled in...[Details]