Notes: 1. All models are also available in an extended temperature range of -40°C~85°C. For these models, append “M” to the model number,
2. Ripple & noise measured with a 20MHz bandwidth, off a 10uF electrolytic and a 0.1uF ceramic cap in parallel at the ouptut.
D
is
For more information, please visit the
product page.
CUI Inc
│
SERIES:
PTK10
│
DESCRIPTION:
DC-DC CONVERTER
date
09/28/2012
│
page
2 of 4
INPUT
parameter
operating input voltage
conditions/description
min
10
20
typ
24
48
max
36
72
units
Vdc
Vdc
OUTPUT
parameter
line regulation
(low line to high line)
load regulation
measured from 10% to full load
voltage accuracy
switching frequency
temperature coefficient
conditions/description
single output
dual output
single output models - no load to full load
dual output models - balanced loads
positive, refer to recommended circuit
negative, refer to recommended circuit
constant
min
typ
±0.5
±1.0
max
units
%
%
%
%
%
%
kHz
%/°C
PROTECTIONS
parameter
over-current
over-voltage
Notes:
conditions/description
internal protection zener
4
in
u
min
105
110
min
77
500
100
580,000
min
-20
-40
-40
5
cui.com
ed
±1
±3
±3
±5
300
±0.03
typ
max
135
140
typ
max
83
typ
max
71
85
105
95
40
300
±1.0
±2.5
units
%
%
continuous, automatic recovery
4
4. continuous operation in a protected state may compromise long-term reliability.
SAFETY AND COMPLIANCE
parameter
efficiency
isolation voltage
insulation resistance
RoHS compliant
MTBF
typical at full load
at 500 Vdc
yes
nt
conditions/description
units
%
Vac
MΩ
hours
input/case, input/output, output/case
ENVIRONMENTAL
parameter
co
conditions/description
MIL-HDBK-217F
units
°C
°C
%
°C
°C
case operating temperature
storage temperature
storage humidity
temperature rise
regular models - see derating curve
extended temperature models
non-condensing
100% load
1.5 mm from the case for 10 seconds
lead temperature
D
DERATING CURVES
output power vs. ambient temperaure
is
For more information, please visit the
product page.
CUI Inc
│
SERIES:
PTK10
│
DESCRIPTION:
DC-DC CONVERTER
date
09/28/2012
│
page
3 of 4
MECHANICAL
parameter
dimensions
case material
weight
conditions/description
2.0 x 1.0 x 0.4 inch (50.8 x 25.4 x 10.16 mm)
Zn
40
g
min
typ
max
units
MECHANICAL DRAWING
units: inches (mm)
D
is
co
cui.com
nt
in
u
ed
Single Output
1. +Vin
2. -Vin
1. +Vin
2. -Vin
3. +Vout
4. No pin
5. -Vout
3. +Vout
4. Com
5. -Vout
Dual Output
For more information, please visit the
product page.
CUI Inc
│
SERIES:
PTK10
│
DESCRIPTION:
DC-DC CONVERTER
date
09/28/2012
│
page
4 of 4
REVISION HISTORY
rev.
1.0
1.01
1.02
description
initial release
updated mechanical drawing
discontinued
date
07/07/2011
03/27/2012
09/28/2012
The revision history provided is for informational purposes only and is believed to be accurate.
D
Headquarters
20050 SW 112th Ave.
Tualatin, OR 97062
800.275.4899
CUI offers a two (2) year limited warranty. Complete warranty information is listed on our website.
CUI reserves the right to make changes to the product at any time without notice. Information provided by CUI is believed to be accurate and reliable. However, no responsibility is
assumed by CUI for its use, nor for any infringements of patents or other rights of third parties which may result from its use.
CUI products are not authorized or warranted for use as critical components in equipment that requires an extremely high level of reliability. A critical
component is any component of a life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to
Let's discuss the selection of components on PCB boards. This is really a super difficult problem. Material selection is very important! ! ! Seeking experience, communication, and secrets....
The manual says there is a reset circuit inside the chip.All kinds of "test boards" have RC reset.Do you guys use external reset circuits on your products?For example, STM809?If not, the NRST pin is l...
[i=s]This post was last edited by azhiking on 2014-3-6 16:29[/i] Operating system: Win7 32-bit IDE: CCS V5.5 Platform: Embest BeagleBone Black (B4) Use TI Resource Explorer of CCS and select Hello Wor...
Headhunting position [Dongguan] Job responsibilities: 1. Mainly for the company's embedded hardware platform, use C/C++ to develop embedded business software as required; 2. Participate in the design,...
This article mainly describes how to modify the network phy chip on the AM335X Linux system, as well as the configuration and use of dual networks. It includes the initialization of phy in uboot and k...
I want to use the high-speed clock of the 149 system. The two pins of XT2 on the PCB are connected to an 8M crystal. My system needs to work at an 8M frequency, andthe serial port also plans to use an...
1 Introduction
The high temperature tester is mainly used for temperature tracking measurement and data acquisition during the heating process. By systematically analyzing the test data, the...[Details]
1. Introduction
This design was made for participating in an electronic design competition. It effectively solved the problem of the operation and control of an electric car on a seesaw. The s...[Details]
With the advent of increasingly powerful processors, image sensors, memory, and other semiconductor devices, as well as the algorithms that enable them, computer vision can be implemented in a wide...[Details]
In recent years, the market for mobile/portable devices such as smartphones and laptops has continued to grow rapidly. While these products continue to integrate more new features to enhance the ...[Details]
In public places such as schools, government agencies, factories and mines, as well as public corridors in residential areas, the phenomenon of long-burning lights is very common, which causes a h...[Details]
1. Introduction
Light control circuit plays a vital role in urban street lamps or corridor lighting. With light control circuit, the lights can be automatically turned on and off according to ...[Details]
The data collector of the automatic weather station is generally designed based on a single-chip microcomputer or a PC/104 bus controller. It has the characteristics of good compatibility with PC, low...[Details]
1. Background:
The instrument system parameter detection and control of the chemical production workshop of Tangshan Coal Gas Coking Plant are all analog instruments, some of which are eve...[Details]
Since the No. 4 blast furnace of Handan Iron and Steel was put into operation in 1993, its external equipment has been seriously aged, and the original PLC control system TDC3000 of the hot blast furn...[Details]
12v Lead Acid batteries used in trucks, cars, RVs and uninterruptible power supplies are usually rated at 12V. This circuit monitors the battery, the charge and discharge curves, gives the cu...[Details]
As people's requirements for safety and comfort in the process of driving cars continue to increase, automotive radars are widely used in the car's adaptive cruise system, collision avoidance syste...[Details]
Today, with energy becoming increasingly scarce, the utilization of natural energy has become the focus of people's attention. Among various natural energies, the endless solar energy is highly fav...[Details]
Since the late 1990s, with the demand for higher system efficiency and lower power consumption, the technological update of telecommunications and data communication equipment has promoted the deve...[Details]
System Overview
The system consists of a signal preprocessing circuit, a single-chip computer AT89C2051, a systematic LED display module, a serial port data storage circuit and system software...[Details]
The above is to use MB1404 as a stereo composite signal transmitter. You can use the internal high-frequency amplifier and oscillator or not! According to my experience, I still recommend beginners...[Details]
PCB Design
京公网安备 11010802033920号
EEWORLD
