The safety of the device is not guaranteed when it is operated above the “Absolute Maximum Ratings”. The device
should not be operated at these “absolute” limits. Adhere to the “Recommended Operating Conditions” for proper device
function. The information contained in the Electrical Characteristics tables and Typical Performance plots reflect the
operating conditions noted on the tables and plots.
Parameter
Power Supply Voltage
V
DD
(Measured to GND)
Inputs
Applied Voltage (measured to GND)
(2)
Forced Current
(3,4)
Outputs
Applied Voltage (measured to GND)
(2)
Forced Current
(3,4)
Short Circuit Duration (single output in HIGH state to GND)
Temperature
Operating, Ambient
Junction
Lead Soldering (10 seconds)
Vapor Phase Soldering (1 minute)
Storage
Min
-0.5
-0.5
-10.0
-0.5
-60.0
Max
7.0
V
DD
+ 0.5
10.0
V
DD
+ 0.5
60.0
unlimited
110
150
300
220
150
Unit
V
V
mA
V
mA
sec
°C
°C
°C
°C
°C
CDK3402/CDK3403
8-bit, 100/150MSPS, Triple Video DACs
-20
-65
notes:
1. Functional operation under any of these conditions is NOT implied. Performance and reliability are guaranteed only if Operating Conditions are not exceeded.
2. Applied voltage must be current limited to specified range.
3. Forcing voltage must be limited to specified range.
4. Current is specified as conventional current flowing into the device.
[i=s]This post was last edited by paulhyde on 2014-9-15 03:57[/i]Using opa820 for preamplification, the amplification is more than 3 times, the simulated bandwidth reaches 43M, but the actual bandwidt...
Requirements: Can add Chinese characters to PCB, no matter whether it is translated into Chinese or not. I downloaded three Protel 99se from the Internet, all of which can be translated into Chinese, ...
I checked a lot of information about CPLD, and I found that the current textbooks are all about how to program, and rarely talk about basic circuits, such as how to design a minimum circuit that can m...
describe View image and its linkdescriptionThe MSP-EXP430FR5739 Experimenter Board is a development platform for the MSP430FR57xx devices. It supports the new generation of MSP430 microprocessor devic...
I just started using CCS2 to program F2812 and encountered many problems. I could not open source file "DSP281x_Device.h". What is the reason? Please give me some advice!...
Participated in the event [url]https://www.eeworld.com.cn/huodong/TIsmartlock_QA_201705/[/url] and was lucky enough to get a 128G USB flash drive, which I received only today. I hurriedly tested the s...