1. Converter will undergo input over-voltage shutdown.
2. Derate output power to 50% of rated power at Tcase = 135ºC. 135ºC is above the specified operating range. See Figure 5.
3. High or low state of input voltage must persist for about 200µs to be acted on by the shutdown circuitry.
4. Current limit inception is defined as the point where the output voltage has dropped to 90% of its nominal value. See Current Limit discussion in
Features Description section.
5. Parameter not tested but guaranteed to the limit specified.
6. Load current transition time ≥ 10µs.
7. Line voltage transition time ≥ 100µs.
8. Input voltage rise time ≤ 250µs.
9. Operating the converter at a synchronization frequency above the free running frequency will cause the converter’s efficiency to be slightly reduced
and it may also cause a slight reduction in the maximum output current/power available. For more information consult the factory.
10. After a disable or fault event, module is inhibited from restarting for 100ms. See Shut Down section of the Control Features description.
11. Only the ES and HB grade products are tested at three temperatures. The C grade products are tested at one temperature. Please refer to the
Construction and Environmental Stress Screening Options table for details.
12. These derating curves apply for the ES and HB grade products. The C grade product has a maximum case temperature of 70ºC.
13. The specified operating case temperature for ES grade products is -45ºC to 100ºC. The specified operating case temperature for C grade products
is 0ºC to 70ºC.
Product# MQHL-28-15S
Phone 1-888-567-9596
www.SynQor.com
Doc.# 005-0005372 Rev. B
08/14/13
Page 4
MQHL-28-15S
Output:
15V
Current:
3.3A
Technical Figures
100
95
90
100
95
90
Efficiency (%)
Efficiency (%)
85
80
75
70
65
60
0.00
16 Vin
28 Vin
40 Vin
85
80
75
70
65
60
-55ºC
16 Vin
28 Vin
40 Vin
0.66
1.32
1.98
2.64
3.30
25ºC
125ºC
Load Current (A)
Case Temperature (ºC)
Figure 1:
Efficiency at nominal output voltage vs. load current for
minimum, nominal, and maximum input voltage at Tcase=25°C.
12
10
Figure 2:
Efficiency at nominal output voltage and 60% rated power vs.
case temperature for input voltage of 16V, 28V, and 40V.
12
10
Power Dissipation (W)
8
6
4
2
0
0.00
16 Vin
28 Vin
40 Vin
Power Dissipation (W)
8
6
4
2
0
-55ºC
16 Vin
28 Vin
40 Vin
0.66
1.32
1.98
2.64
3.30
25ºC
125ºC
Load Current (A)
Case Temperature (ºC)
Figure 3:
Power dissipation at nominal output voltage vs. load current
for minimum, nominal, and maximum input voltage at Tcase=25°C.
4.0
3.3
2.6
59
50
40
Figure 4:
Power dissipation at nominal output voltage and 60% rated
power vs. case temperature for input voltage of 16V, 28V, and 40V.
18
16
14
Output Voltage (V)
12
10
8
6
4
2
Iout (A)
2.0
30
1.3
Tjmax = 105º C
0.7
0.0
25
45
65
85
105
125
Tjmax = 125º C
Tjmax = 145º C
20
10
0
145
Pout (W)
0
0
1
Case Temperature (ºC)
Load Current (A)
2
3
4
5
Figure 5:
Output Current / Output Power derating curve as a
function of Tcase and the Maximum desired power MOSFET junction
temperature at Vin = 28V (see Note 12).
Product# MQHL-28-15S
Phone 1-888-567-9596
Figure 6:
Output voltage vs. load current showing typical current limit
I just DIYed a 1680 dot matrix screen and would like to share it with you. Please point out some shortcomings and areas that need improvement. Please feel free to give me your advice! :titter:
The pho...
I drew a new board and made ten of them for experiment. But there was a problem during the experiment. When the power was on, the program sometimes did not run. But after shutting down and restarting,...
Radio frequency cable connectors are something we often come into contact with in our daily lives, and many people need to choose and purchase them themselves. So, which radio frequency cable connecto...
[i=s] This post was last edited by serialworld on 2018-10-4 07:30 [/i] Is it possible to use the math functions provided by the compiler after GD32F350 turns on FPU? The program crashes after calling ...
Experts, please take a look at this program. You don't have to read the whole program. There are comments. Just look at the part that sets up the LCD1602. This is my first time writing a program for L...
In circuit design and PCB production, we often encounter power symbols: VCC, VDD, VEE, VSS. What is the relationship between them? 1. Explanation VCC: C = circuit, which means the voltage connected to...
1. Overview
Will passive devices
produce nonlinear intermodulation distortion? The answer is yes! Although there is no systematic theoretical analysis, it has been found in engineerin...[Details]
From the PIC16F946 datasheet, we know that there are two ways to write values to the LCD for display:
1. Directly write the value to LCDDATA1~LCDDATA23
2. Use disconnect t...[Details]
Experimental tasks
A DS18B20 is used to form a temperature measurement system. The temperature measurement accuracy reaches 0.1 degrees. The temperature range is between -20 degrees and +50 de...[Details]
At very low temperatures, certain metals and alloys lose their resistance to electric
current
and become
superconductors
. Two parameters that are often measured are the transition ...[Details]
Problems such as the depletion of natural resources, air pollution, traffic congestion, and rising fossil fuel prices have forced societies and individuals to seek alternative means of transportati...[Details]
Motors, especially those with brushes, generate a lot of noise. This noise must be dealt with if the appliance is to meet the requirements of EMC standards. The means to solve EMC are nothing more ...[Details]
In 2012, more than half of the cars in the European, Japanese and American car markets will be equipped with color displays, navigation systems, satellite communications and other in-vehicle infota...[Details]
At present, the traffic congestion in cities is quite serious. According to relevant news reports: In China, the traffic congestion has expanded from megacities such as Beijing, Shanghai, and Guangzho...[Details]
Liquid crystal display (LCD) panels have a wide range of applications, from small portable electronic devices to large fixed devices, including digital cameras, laptops, personal data assistants, d...[Details]
With the rapid development of wireless
digital communication
, more challenges have been raised for integrated circuit design and testing. In the product design stage, in order to ensure
t...[Details]
The launch of Shenzhou IX is imminent, and Tiangong is welcoming visitors again. Yesterday, Professor Fu Qiang, Vice President of the Institute of Science and Industrial Technology of Harbin Instit...[Details]
When the so-called "copycat phones" that flood the domestic mobile phone market move towards large screens, stereo amplifiers, touch controls, and even GPS navigation and mobile TV, the homogeneity...[Details]
LED is the abbreviation of the English word. Its main meanings are: LED = Light Emitting Diode, a solid-state semiconductor device that can convert electrical energy into visible light. It can dire...[Details]
1 Battery technology determines the fate of energy vehicles
Regardless of whether new energy vehicles are hybrid or pure electric vehicles, they cannot do without the core technology of batter...[Details]
The power supply is the core component of a computer. Although it is not of high value, all computer components rely on the switching power adapter to provide energy, so the stability of a power su...[Details]
51mcu
京公网安备 11010802033920号
EEWORLD
