-
1 Introduction
There have been many studies on the detection and protection of power grid short circuit and line fault. The short circuit, overload and overvoltage protectors on the market have ...[Details]
-
Single-chip microcomputers are widely used because of their small size, powerful functions and low price. This article introduces the method of designing a micro electronic piano using the AT89C51 sin...[Details]
-
With the rapid development of the national economy, lifting and hoisting operations are used more and more frequently and widely in various fields of economic construction. China has continuously expl...[Details]
-
introduction
At present, the research on micron and nanotechnology is very active, which has led to the rapid development of microtechnology and micro-mechanical electronic system (MEMS) t...[Details]
-
IntroductionLED
billboards are a kind of information display terminal for the public, which has a wide range of civil and commercial values. However, the information displayed on most LED bil...[Details]
-
1. Introduction
AS-Interface bus technology is an intelligent network that uses a single cable to connect sensors and actuators to controllers, transmit data, and provide power. It can be used...[Details]
-
0 Introduction
In microwave, radar, radio and television, and communication systems, the problem of coupling RF power is often encountered. A directional coupler is a directional power divide...[Details]
-
introduction
This paper mainly studies the problem of voltage sag control. For sensitive load equipment with rectifier inverter structure, this paper proposes a DC dynamic voltage restorer (Dy...[Details]
-
When programming in C and assembly, there are interface issues between variables and functions in C and assembly.
Variables defined in a C program are put into the .bss area after being compile...[Details]
-
FSP107-2PS01 two-in-one power supply assembly is mainly used with LG 26-inch screens to directly drive CCFL lamps, as shown in Figure 1. If used with screens from other manufacturers (such as Sams...[Details]
-
PPTC device technology has been widely used in overcurrent and overtemperature circuit protection designs for portable appliances, cell phones, computers and telecommunications equipment. New stand...[Details]
-
1 Power Module Design
The power supply in this study is directly connected to the neutral and live wires, and converted through the lnk306 chip. The 13V voltage required by the control mod...[Details]
-
Preface
For a new antenna, we usually care about its
three main performance indicators:
standing wave
coefficient, gain and radiation pattern. In a suitable microwave darkroom, these th...[Details]
-
1 Overview
In microwave detection systems, antennas are usually the closed loop points of the system's automatic control loop. As an important part of a receiving/transmitting control...[Details]
-
Zero voltage switch controller integrated circuits can be used to control resistive heater loads. This type of controller generates an output pulse when the mains passes zero to trigger the bidirec...[Details]