My program has been compiled, and the circuit design uses the JTAG interface. I originally used IAR Embedded Workbench to load the program, and then used the debugger in it to write the program into t...
[i=s] This post was last edited by fhlso on 2018-8-18 14:37 [/i] This is a linear isolation circuit. No matter how much the input is, the output is 0. When the input point A is 0v, point B has a volta...
Who can help me? I need to use the timing and counting function of the microcontroller to complete a project, but I am a beginner in microcontrollers and I am not very good at using it. I would like t...
In early 2002, I started to write a working program for an IC card prepaid electricity meter. The meter used Philips' 8-bit 51-expanded single-chip microcomputer
87LPC764
, and wa...[Details]
introduction
1 The significance of using RTOS on MSP430
It is understandable that it is meaningless to use RTOS on MSP430. Because the hardware resources of MSP430 are limited (for exampl...[Details]
Microcontrollers (MCUs), which are widely used in automotive electronics, are rapidly facing time and cost pressures. The main advantage of using MCUs has always been to create high-level system in...[Details]
With the continuous improvement of the requirements of intelligent building security systems and the continuous improvement of people's safety awareness, indoor anti-theft has gradually attracted peop...[Details]
LED technology has made rapid progress, and improvements in chip design and materials have promoted the development of brighter and more durable light sources, and the scope of light source applica...[Details]
a. Keep the battery clean, wipe off the spilled electrolyte, contaminated dirt and dust in time; keep the poles and terminal clamps clean and in good contact, and apply vaseline or butter to preven...[Details]
When developing electronic products with processors, how to improve anti-interference ability and electromagnetic compatibility?
1. The following systems should pay special attention to anti-...[Details]
O Introduction
Virtual instrument is a new type of instrument developed with
the development of
computer
technology, electronic measurement technology and communication technology. ...[Details]
1. Introduction
According to the definition of the International Electrotechnical Commission (IEC) and the American Instrument Society (ISA), fieldbus is a digital, two-way transmission, multi...[Details]
1. Introduction
PROFIBUS is an international, open asynchronous serial communication standard, which is widely used in manufacturing automation and process automation, buildings, transportatio...[Details]
In order to reduce the proportion of data transmission time in the entire system processing time index, the data transmission rate should be no less than E1 (2.048Mb/s), and the communication...[Details]
In the "mistress war", Zhou Hongyi constantly questioned Lei Jun, firing at Lei Jun on issues such as the cost, profit, configuration, and marketing methods of Xiaomi mobile phones.
The "m...[Details]
Abstract A two-dimensional sound source directional system is designed using the ADSP BF533 DSP processor. The system is based on the time difference of arrival of sound waves and uses a phase matc...[Details]
Abstract: In a digital signal processing system with DSP as the core, analog-to-digital conversion is an important part of the system. Taking
TMS320C6203B and ADS5422 of
Texas Instruments
...[Details]
Abstract: This paper introduces the design of a new linear array CCD drive circuit based on single chip microcomputer. The system uses C8051F020 single chip microcomputer as the lower computer to c...[Details]
Analogue and Mixed Signal
京公网安备 11010802033920号
EEWORLD
