This article is reproduced from the Internet1. Write tcl file
(1) Create a new Tcl Scripe File in Quartus . The format of the file content is as follows:
#setup.tcl #setup pin setting set_global_assig...
I have just started to learn about single-chip microcomputers and I am quite interested in them. I would like to ask what the future of single-chip microcomputers is and whether there is room for deve...
The clock module is an indispensable module of the MSP430 series microcontroller. The clock module can enable the microcontroller to achieve different low-power applications. Different devices have di...
For 80,000
ZTE
(000063.SZ) employees and more Chinese ICT (information and communication technology) industry practitioners, the news from across the ocean on the evening of April 16 kept t...[Details]
In the
AI
boom, the most talked about is
neural network
. However,
AI
is much more than that. Let's learn about the relevant content with the network communication editor.
...[Details]
In the actual project development process, we often need to get the running time of a section of code. The usual method is to use an oscilloscope to measure it. This blog post will use SysTick to acc...[Details]
LAN8720 configuration: IP: 192.168.192.30 Gateway: 192.168.192.1 A high frequency of ARP packets is detected The content of the packet asks for the mac address of 192.168.192.1, and asks the resp...[Details]
Timing and protocol are two key points in digital system debugging, and they are also where logic analyzers can play their most valuable role. How can we use a logic analyzer to quickly complete wiri...[Details]
As the weather gets colder, the way the north and south spend the winter has become a hot topic and people talk about it. Although the north is particularly cold, because there is heating, it can s...[Details]
The independent watchdog of STM32 is driven by a dedicated internal 40Khz low-speed clock, that is, it is still effective even if the main clock fails. Here we need to note that the clock of the inde...[Details]
Note: This STM32 microcontroller is the STM32F103 series. The ADC of Stm32 has DMA function. This is beyond doubt and is what we use most! However, if we want to sample a signal (such as a pulse sign...[Details]
/* Unfortunately, it cannot generate a standard 38kHz frequency square wave, there is a little error*/ #include reg51.h #define uchar unsigned char #define uint unsigned int sbit Waveout=P1^0; //P...[Details]
The single-chip microcomputer running light program requires all 32 serial ports to be used, and each serial port has eight LEDs. Question supplement: The 8051 single-chip microcomputer is used, an...[Details]
A simple experimental programming question for the microcontroller: write a 3-byte binary addition subroutine. The program entry is: addend 1: 22H, 21H, 20H three bytes, 22H is the highest bit; adden...[Details]
As shown in the figure, the circuit is required to count and display the number of times the button is pressed. When the button is pressed once, the count value increases by 1 (it is required to accu...[Details]
1. Pin: 0 in 1 out Set Status Output status IO register setting DDR×A certain bit is set to 1, and the corresponding bit IO is set to output; PORT×A certain position is 1/0, and t...[Details]
FPGA/CPLD
京公网安备 11010802033920号
EEWORLD
