[i=s] This post was last edited by paulhyde on 2014-9-15 09:09 [/i] If you are doing this year's Electronic Design Competition B, please log in or use QQ, 419605141...
From 8-bit/16-bit single-chip microcomputers to 32-bit embedded processors represented by ARM CPU cores, embedded operating systems will replace traditional manually compiled monitoring programs or sc...
I would like to ask you all: If I want to achieve the line drawing function, I can capture WM_MOUSEMOVE and WM_LBUTTONDOWN, or should I implement the messages sent by the driver?...
The optical signal is converted into an electrical signal and input into the AD port of the DSP. Then the size of the water drop and the falling time are calculated by calculating the voltage change a...
[size=4]Android's low-power Bluetooth applications are very common. Smart bracelets and watches are everywhere, and they basically use BLE communication to exchange data. BLE is basically well support...
The following stream driver code is written corresponding to the DeviceIOControl function: BOOL TES_IOControl (DWORD dwCtx, DWORD dwCode, PBYTE pInpBuf, DWORD dwInpLen, PBYTE pOutBuf, DWORD dwOutLen, ...
High efficiency and low standby power consumption are two major challenges in today's switching power supply design. Resonant topology or LLC topology is becoming increasingly popular because it ca...[Details]
1. Introduction
RFID (radio frequency identification) is a non-contact automatic identification technology that emerged in the 1990s. It uses the characteristics of radio frequency signal prop...[Details]
This article discusses how to wake up a touch-sensitive device such as a tablet without touching the device, using basic gesture recognition and novel proximity sensors. The article discusses the p...[Details]
Electronic systems are located at different points on the automotive power bus and therefore often need to operate under very stringent power requirements. These include load dump, cold crank, very lo...[Details]
With the development and widespread application of computer technology, especially in the field of industrial control, computer communication is particularly important. Although serial communication g...[Details]
Vertical cavity surface emitting lasers (VCSELs) are gradually replacing traditional edge emitting lasers, especially in low bandwidth and short-distance communication systems where cost factors ar...[Details]
I. Introduction
Since RS232 has a short communication distance (only 15 meters according to EAT/TAI-232 standard), and can only perform point-to-point communication, it cannot directly f...[Details]
1. System Structure
This system is a simulation system of indoor air-conditioning temperature/humidity control system. The data acquisition and control center collects temperature/humidity...[Details]
1. Introduction
Testing the temperature of steel billets before rolling is an important measure to ensure the quality of steel. Traditional manual testing is difficult to ensure product qu...[Details]
Digital array radar (DAR) uses digital beam forming (DBF) in both receiving and transmitting modes to achieve flexible distribution and reception of RF signal power in the airspace, obtain excellent t...[Details]
12v Lead Acid batteries used in trucks, cars, RVs and uninterruptible power supplies are usually rated at 12V. This circuit monitors the battery, the charge and discharge curves, gives the cu...[Details]
TC9012F is a universal CMOS large-scale integrated circuit for infrared remote control signal transmission, suitable for remote control of TV, VTR, laser player and other equipment. In the market, ...[Details]
LED guardrail lights use fluorescent tubes or LEDs as light sources and continuous guardrails as carriers to form an approximately linear guardrail light strip. This article mainly introduces...[Details]
introduction
Steam turbines are driven by high-temperature and high-pressure steam generated by boilers to run at high speed. They are key power equipment in thermal power plants. The emergenc...[Details]