I521-2Q3-20.000

1. Introduction RFID (radio frequency identification) is a non-contact automatic identification technology that emerged in the 1990s. It uses the characteristics of radio frequency signal prop...[Details]

1 Introduction The high temperature tester is mainly used for temperature tracking measurement and data acquisition during the heating process. By systematically analyzing the test data, the...[Details]

Electronic systems are located at different points on the automotive power bus and therefore often need to operate under very stringent power requirements. These include load dump, cold crank, very lo...[Details]

1. Introduction Testing the temperature of steel billets before rolling is an important measure to ensure the quality of steel. Traditional manual testing is difficult to ensure product qu...[Details]

Today, with energy becoming increasingly scarce, the utilization of natural energy has become the focus of people's attention. Among various natural energies, the endless solar energy is highly fav...[Details]

Multimedia processors are often the most power-hungry devices in portable electronic devices. Common ways to reduce CPU power requirements are to reduce clock frequency or operating voltage, but th...[Details]

1 Introduction Automatic Test System The ATS (Automatic Test System) integrates all the stimulus and measurement equipment required for testing. The computer efficiently comp...[Details]

1. Introduction AS-Interface bus technology is an intelligent network that uses a single cable to connect sensors and actuators to controllers, transmit data, and provide power. It can be used...[Details]

0 Introduction The load with impact (rapid change) power in the power system will cause the voltage fluctuation and flicker of the power grid, causing many electrical equipment to fail to wo...[Details]

TPMS is the abbreviation of "Tire Pressure Monitoring System". It is mainly used to automatically monitor the tire pressure in real time when the car is driving, and to alarm for tire leakage and l...[Details]

During the operation of electronic equipment, memory failure or failure will not only lead to economic losses, but also may lead to catastrophic consequences. Therefore, memory testing has ...[Details]

In the process of designing electronic products, we usually control the cost of the designed products, always try to simplify the circuit, reduce the components, and simplify the installation process....[Details]

With the development of control, computer, communication and network technology, computer network integrated automation system has been widely used in modern industrial enterprises. The emergence o...[Details]

Abstract Based on the overview of the hardware design of digital synthesis sweeper, this paper describes a USB2.0 interface design based on ISP1362, including the hardware structure design of USB i...[Details]

0 Introduction A wireless sensor network is a type of RGS system (remote ground sensor system). It is a detection system that uses a variety of sensors as comprehensive intelligence collection...[Details]