[i=s]This post was last edited by yang_alex on 2015-3-15 10:34[/i] The most common scenarios for GPIO in applications are lighting (LED) and pressing keys (SW). Other applications are very similar to ...
How do I print the contents to a file in Tcl ? For example, the following sentence: puts [ format "%40s%13s%13s%13s" "name" "num" "code" "com"] will print the corresponding characters in the modelsim ...
[i=s]This post was last edited by tclone on 2017-6-14 15:04[/i] I got a TPS54260 test version from TI. I found a problem and need some advice: When I convert 12V to 5V and connect the output to a resi...
Recently, I have been looking at information and looking for pin positions, mainly for various module interfaces. It must be compatible with the official board and ensure easy wiring in the future. Th...
1. To configure a serial port, it is omitted here.2. To configure and use printf,just add the following redirection code:
//Support functions required by the standard librarystruct __FILE{int handle;}...
[i=s]This post was last edited by paulhyde on 2014-9-15 09:15[/i] [i=s]This post was last edited by paulhyde on 2014-9-15 09:15[/i] Poor load capacity is not necessarily a problem of regulation rate. ...
Traditional broadcasting systems generally need to be operated manually at a fixed time, and can only realize one-way broadcasting with few functions. Traditional bell ringing equipment has a singl...[Details]
introduction
Since the beginning of the 21st century, the world of information has changed rapidly. Maybe a high-tech product will be released today and a better similar product will be releas...[Details]
1. Introduction
RFID (radio frequency identification) is a non-contact automatic identification technology that emerged in the 1990s. It uses the characteristics of radio frequency signal prop...[Details]
1. Circuit composition
The whole circuit consists of two parts:
1. Power saving control circuit
As shown in the figure below. Including delay circuit and drive circuit.
(1) Delay ci...[Details]
At present, the traffic congestion in cities is quite serious. According to relevant news reports: In China, the traffic congestion has expanded from megacities such as Beijing, Shanghai, and Guang...[Details]
China's new energy vehicles are in a transition period from research and development to real industrial development. In 2012, with the intensive launch of new energy vehicle policy planning, the de...[Details]
1. Introduction
With the growth of parking demand, the scale of parking lots is becoming larger and larger. A lot of research has been done on intelligent parking lots in China, but most of th...[Details]
1. Introduction
Since the 1980s, with the continuous development of automotive electronic technology, there are more and more electronic control units in automobiles, such as electronic fuel i...[Details]
Analog engineers have traditionally struggled with complexity when designing power supplies that required multiple outputs, dynamic load sharing, hot-swap, or extensive fault-handling capabilities....[Details]
Converged processors meet scalability requirements
In current embedded system design, solutions based on MCU, DSP, FPGA and ASIC account for more than 90% of the market share. These solutions ...[Details]
The reason for the light decay of white LEDs: the decline of phosphor performance
So far, the rapid decline of the luminous performance of white light LEDs, especially low-power white light LE...[Details]
Electronic systems are located at different points on the automotive power bus and therefore often need to operate under very stringent power requirements. These include load dump, cold crank, very lo...[Details]
1. Principle of displacement angle sensor
The angle sensor is used to detect angles. It has a hole in its body that fits the LEGO axle. When connected to the RCX, the angle sensor counts once ...[Details]
1. Introduction
Testing the temperature of steel billets before rolling is an important measure to ensure the quality of steel. Traditional manual testing is difficult to ensure product qu...[Details]
Corelink Semiconductor has launched the CL1100-based 5-7W E27 LED lighting driver system solution DB2. This driver module meets the requirements of small size (L×W×H=5.1cm×2.1cm×1.8cm), low standby...[Details]
Microchip MCU
京公网安备 11010802033920号
EEWORLD
