The ZR36067 is a PCI adapter intended for multimedia applica-
tions on PCI systems. It supports high rate code (compressed
data stream) transfer between the system memory and JPEG or
MPEG processors. Simultaneously to the code transfer, the
ZR36067 captures digital video, such as decompressed MJPEG
(Motion JPEG), MPEG, or the output of a video decoder, and
creates a scaled video window in the graphics display memory.
The ZR36067 provides the host software with full control over a
large number of non-PCI multimedia devices:
• Motion JPEG Codecs - ZR36050+ ZR36016, ZR36060
• Audio codecs
• MPEG and DVD decoders - ZR36110, ZR36700
• I2C devices, such as video decoders, video encoders, etc.
The ZR36067 interfaces directly to the PCI bus. As a bus
master, it transfers data (e.g, JPEG compressed data) to or from
the system memory, and writes digital video pixels to the
graphics display memory. As a bus target, the ZR36067 reflects
the host accesses onto a micro-controller-type 8-bit “Guest Bus”.
The ZR36067 has a special “Still Transfer” port by means of
which the host software writes (or reads) digitized video, as RGB
pixels, from the system memory to (or from) the video bus. This
path enables fast transfer of still images to be compressed (or
decompressed) by the JPEG chip set.
The ZR36067 supersedes the ZR36057 PCI Bus Multimedia
Controller and is recommended for all new designs. The
ZR36067 has the same package, pinout and functions and the
ZR36057, with the following exceptions:
• The ZR36067 supports programmable PCI Subsystem ID
and Subsystem Vendor ID. These ID registers get their val-
ues by sampling the state of existing pins of the ZR36067
(Video bus, Guest bus and GPIO pins) at PCI Reset time.
Thus, the values can be programmed by means of pull-up or
pull-down resistors on these pins. Note that the Subsystem
ID and Subsystem Vendor ID registers of the ZR36057 are
hard wired to 0.
• Two functional bugs of the ZR36057, documented in its data
sheet, have been corrected in the ZR36067 and work-
arounds are no longer required.
• Still Image Decompression.
1.2.1 Motion Video Compression
The video decoder directs the video in YUV 4:2:2 format, and the
video synchronization signals, to the video input port of the
ZR36060. The video is also transferred to the video encoder for
display on a TV monitor and simultaneously to the Video Front
End of the ZR36067. The ZR36067 can optionally down-scale
the video, convert it to RGB, and transfer the pixels using DMA
to the display memory of the host PC. In parallel, the ZR36060
performs the JPEG compression. The ZR36050 drives the
JPEG code stream to the Codec Front End of the ZR36067,
which transfers the compressed video fields using DMA to a
system memory buffer allocated by the host.
1.2.2 Motion Video Decompression
In Motion Video Decompression, the ZR36067 transfers the
code stream from system memory via the ZR36067 Codec Front
End to the ZR36060, using DMA. The ZR36060 decompresses
the JPEG code and transfers the video to the video encoder to
be displayed on a TV monitor. The ZR36060 video output is
driven simultaneously to the Video Front End of the ZR36067 to
be processed, as in the compression mode, and transferred
using DMA to the PC display memory.
1.2.3 Still Image Compression
In Still Image Compression mode an image bitmap is written by
the host, pixel by pixel, through the PCI bus to the ZR36067. The
ZR36067 transfers the pixels through its video bus port to the
video input port of the ZR36060. The ZR36067 generates and
drives the required video synchronization signals for the
ZR36060 in this mode. After the first strip of 8 video lines is filled,
the ZR36060 starts performing the raster-to-block operation and
compressing the data, and drives the code stream to the
ZR36067. The code stream is transferred using DMA to the host
memory as in Motion Video Compression.
1.2.4 Still Image Decompression
In Still Image Decompression mode, the ZR36067 fetches the
code stream from system memory using DMA, as in Motion
Video Decompression. The ZR36060 reads the compressed
data from the ZR36067, decodes it and send the decompressed
video to the video port of the ZR36067. From there the host
software reads it out to system memory, pixel by pixel.
Note that still image decompression can also be accomplished
by configuring the ZR36067 in Motion Video Decompression
mode, and transferring the decompressed video to a contiguous
buffer in system memory instead of the display memory. Since
this has a speed advantage over Still Image Decompression
mode, it is the preferred method for most applications.
1.2 JPEG System Overview
Figure 1 depicts an example of an MJPEG add-on board, using
the ZR36067 and ZR36060.
The ZR36067 supports 4 basic JPEG modes of operation:
• Motion Video Compression.
• Motion Video Decompression.
• Still Image Compression.
4
AV PCI CONTROLLER
1.2.5 Notations and Conventions
External signals:
Active-low
mark
[1]
:
Capital letters (e.g., IDSEL)
Overbar (e.g., DEVSEL)
capital (non-bold) letters (e.g., VFE)
XXmsb_index..lsb_index (e.g., AD31..0)
XXmsb_index:lsb_index (e.g., Mode27:16)
R - read only
RC - read-clear. Writing ‘1’ clears the register bit.
RS - read-set. Writing ‘1’ sets the register bit to ‘1’.
RW - read-write (contents of write can be read back)
W - write only (contents of read are meaningless)
Unmarked numbers are decimal (e.g., 365, 23.19). Hexadecimal numbers are marked with a ‘0x’ prefix (e.g., 0xB000,
0x3). Binary numbers are marked with a ‘b’ suffix (e.g., 010b, 0000110100011b).
Internal function units:
Buses:
Register fields:
Register types:
Numbers:
1. In this document, an overbar is used to denote active low signals. In other documents referenced herein, such as the PCI specifications, the # suffix notation is often
used instead. The two forms of notation are interchangeable. Thus, for example, DEVSEL is equivalent to DEVSEL#.
I am new to the point drawing function W_DOT void __fastcall TForm1:: W_DOT(int O_X,int O_Y) { unsigned char i,j,dat; unsigned int k; j=PARA;//PARA=0x30； i=O_X%8; O_X=O_X/8; k=j*O_Y+O_X+0x4000; /* Dis...
I need a function to directly open Settings in Wince instead of a certain item. I tried \Windows\ctlpnl.exe cplmain.cpl. This command line doesn't work. Running ctlpnl.exe directly doesn't work either...
RT My board is F5529. For example, I choose 32768Hz crystal as ADC12CLK and set ADC12SHTx to 256 sampling cycles SHP=1, then the sampling time is 4*256*1/32768=0.03125s ?????? Then the reciprocal shou...
When I used T21, the original Windows was in English. After I installed the Chinese version, Ultrabay and hibernation did not work. I checked on the IBM website and found that the power management mod...
[i=s]This post was last edited by cardin6 on 2017-9-15 12:04[/i] There is nothing much to introduce and I won’t talk too much. I will try my best to release at least one new work every week. Why do I ...
The intelligent driving community has its own rhythm. Some are busy pushing new versions and focusing on R&D, others are busy with publicity and promotion, and still others are immersed in mass pro...[Details]
EtherCAT (Ethernet for Control Automation Technology) is a real-time industrial fieldbus communication protocol based on an Ethernet-based development framework. EtherCAT is one of the fastest indu...[Details]
A line scan lens is an industrial lens used with line scan cameras. Its imaging principle is to capture the image of the workpiece using a linear sensor and then perform digital signal processing t...[Details]
The jammer is a signal blocker, mainly composed of a chip and a radio transmitter. When the car owner presses the remote control lock button, the jammer interferes with the electronic lock receivin...[Details]
New energy vehicles are increasingly popular with consumers due to policies and energy conservation. Once you've purchased your vehicle, maintenance is essential. However, due to the different powe...[Details]
Long ago, the lifespan of cars in my country was 15 years. Once a car reached 15 years old, it was forced to be scrapped. However, the policy was later changed. As long as the car does not exceed 6...[Details]
The structure of an LCD TV primarily consists of the LCD display module, power module, driver module (primarily including the main driver board and tuner board), and keypad module. LCD display modu...[Details]
On August 25th, SK Hynix announced that it has completed development and entered mass production of its 321-layer, 2Tb QLC NAND flash memory product. This achievement marks the world's first applic...[Details]
In the summer of 2025, BlueOval SK, a joint venture between Ford and SK On, officially started production at its first battery factory in Kentucky.
According to the original plan, this w...[Details]
1 Source of creativity
With the further development of electronic technology, electronic pets have gradually entered people's family life. At present, there are two main categories of relative...[Details]
introduction
As “energy conservation and emission reduction” has become an indicator of the National Economic Development Outline of the 11th Five-Year Plan, people’s awareness of green enviro...[Details]
The digital TV set-top box consists of a tuner, QAM demodulator, TS demultiplexer, MPEG-2 decoder, PAUNTSC video encoder, embedded CPU system and peripheral interfaces, CA module, and uplink data m...[Details]
Smartphones have become essential digital devices, and the growing number of smartphone-centric applications is enriching people's lives. As users, they desire a better app experience and a wider r...[Details]
With the development of science, the use of variable frequency technology is becoming more and more widespread, and it is used in both industrial equipment and household appliances. Inverter air co...[Details]
In the scorching summer, electric fans are a must-have for cooling down people's homes. However, I believe most people have encountered this situation: the fan is plugged in, the switch is pressed,...[Details]
Embedded System
京公网安备 11010802033920号
EEWORLD
