[i=s]This post was last edited by a985872z on 2016-2-3 14:49[/i] Hello everyone, I would like to ask about the connection method of the crystal head: 1. The network cable in my house is: one end is in...
Dear electronics industry experts, I would like to ask you a question and hope to get your answer. In the next 10 years, will the development space of hardware or software be bigger? Now I personally ...
After-class Exercise 22: UCOS Simple Semaphore1. Semaphore (from Mr. Ren Zhe's book)
Semaphores are a type of event. The original purpose of using semaphores is to set a flag for shared resources, whi...
The power supply is burning itself while providing energy to the load. When designing a power supply, people will carefully analyze the load requirements, but they tend to ignore the heat consumption ...
The project I am involved in needs to implement a function to wirelessly control the on and off of LED lights at short distances. The specific requirements are as follows: In a room, there are many bo...
When the WDP500-2A plane grating monochromator is used to test the emission wavelength of a high-power laser diode at different currents, the matching of the laser diode has the disadvantages of lo...[Details]
Battery life is critical for portable applications. For applications such as smoke detectors, security devices, and thermostats, factory-installed batteries need to last for more than 10 years. The...[Details]
0 Introduction
With the rise and continuous improvement of the solid-state lighting industry, light-emitting diodes (LEDs) have become an alternative lighting technology and are gr...[Details]
Capacitors
are basic components in various electronic devices and are widely used for bypassing, coupling,
filtering
, tuning, etc. in electronic circuits. However, to use capacitors,...[Details]
With concerns about the growing energy crisis, motor efficiency has become an important and timely topic. This is because motors use 63% to 70% of the electricity produced in the United States and ...[Details]
0 Introduction
Ultrasonic waves
are mechanical waves with a frequency of more than 20KHz, and the propagation speed in the air is about 340 m/s (at 20°C). Ultrasonic waves can be gene...[Details]
In industry, voltage 0…5 (10) V or current 0 (4)…20 mA is usually used as a method for analog signal transmission, which is also a method often used by programmable controllers. So what are the dif...[Details]
HL201A is a special thick film driver integrated circuit with a capacity of less than 75AGTR developed by Xi'an Power Electronics Technology Research Institute. The article explains the pin arrange...[Details]
The principles to be followed are as follows:
(1) In terms of component layout, related components should be placed as close as possible. For example, clock generators, crystal oscillat...[Details]
Abstract: Based on the analysis of the characteristics of the IRIG-B (DC) code type, a design method for IRIG-B (DC) time code decoding is proposed. This method consists of a small number of periph...[Details]
Traditional synthesis techniques are increasingly unable to meet the needs of today's very large and complex FPGA designs implemented in 90nm and below process nodes. The problem is that traditio...[Details]
As the automobile consumer market heats up, the safety performance of automobiles has attracted more attention from consumers. When driving at high speed, tire failure is the most worrying and diff...[Details]
During the operation of electronic equipment,
memory
failure or failure will not only lead to economic losses, but also may lead to catastrophic consequences. Therefore, memory testing has ...[Details]
The Challenge:
Protect historical relics by monitoring environmental factors without affecting their original appearance.
The Solution:
Developed a monitoring system for the...[Details]
Some experience we have accumulated when debugging a system using Keil C
1. Since Keil C does not support Chinese very well, the displayed cursor will be inconsistent with the actual cursor positi...[Details]