are trademarks of Altera Corporation and registered in the U.S. Patent and Trademark Office and in other countries. All other words and logos identified as
trademarks or service marks are the property of their respective holders as described at
www.altera.com/common/legal.html.
Altera warrants performance of its
semiconductor products to current specifications in accordance with Altera's standard warranty, but reserves the right to make changes to any products and
services at any time without notice. Altera assumes no responsibility or liability arising out of the application or use of any information, product, or service
described herein except as expressly agreed to in writing by Altera. Altera customers are advised to obtain the latest version of device specifications before relying
on any published information and before placing orders for products or services.
ISO
9001:2008
Registered
Stratix IV Device Handbook
Volume 1
September 2012
Feedback Subscribe
1–2
Chapter 1: Overview for the Stratix IV Device Family
Feature Summary
Feature Summary
The following list summarizes the Stratix IV device family features:
■
Up to 48 full-duplex CDR-based transceivers in Stratix IV GX and GT devices
supporting data rates up to 8.5 Gbps and 11.3 Gbps, respectively
Dedicated circuitry to support physical layer functionality for popular serial
protocols, such as PCI Express (PCIe) (PIPE) Gen1 and Gen2, Gbps Ethernet (GbE),
Serial RapidIO, SONET/SDH, XAUI/HiGig, (OIF) CEI-6G, SD/HD/3G-SDI, Fibre
Channel, SFI-5, and Interlaken
Complete PCIe protocol solution with embedded PCIe hard IP blocks that
implement PHY-MAC layer, Data Link layer, and Transaction layer functionality
f
For more information, refer to the
IP Compiler for PCI Express User Guide.
■
■
■
Programmable transmitter pre-emphasis and receiver equalization circuitry to
compensate for frequency-dependent losses in the physical medium
Typical physical medium attachment (PMA) power consumption of 100 mW at
3.125 Gbps and 135 mW at 6.375 Gbps per channel
72,600 to 813,050 equivalent LEs per device
7,370 to 33,294 Kb of enhanced TriMatrix memory consisting of three RAM block
sizes to implement true dual-port memory and FIFO buffers
High-speed digital signal processing (DSP) blocks configurable as 9 x 9-bit,
12 x 12-bit, 18 x 18-bit, and 36 x 36-bit full-precision multipliers at up to 600 MHz
Up to 16 global clocks (GCLK), 88 regional clocks (RCLK), and 132 periphery
clocks (PCLK) per device
Programmable power technology that minimizes power while maximizing device
performance
Up to 1,120 user I/O pins arranged in 24 modular I/O banks that support a wide
range of single-ended and differential I/O standards
Support for high-speed external memory interfaces including DDR, DDR2,
DDR3 SDRAM, RLDRAM II, QDR II, and QDR II+ SRAM on up to 24 modular
I/O banks
High-speed LVDS I/O support with serializer/deserializer (SERDES), dynamic
phase alignment (DPA), and soft-CDR circuitry at data rates up to 1.6 Gbps
Support for source-synchronous bus standards, including SGMII, GbE, SPI-4
Phase 2 (POS-PHY Level 4), SFI-4.1, XSBI, UTOPIA IV, NPSI, and CSIX-L1
Pinouts for Stratix IV E devices designed to allow migration of designs from
Stratix III to Stratix IV E with minimal PCB impact
■
■
■
■
■
■
■
■
■
■
■
Stratix IV Device Handbook
Volume 1
September 2012 Altera Corporation
Chapter 1: Overview for the Stratix IV Device Family
Feature Summary
1–3
Stratix IV GX Devices
Stratix IV GX devices provide up to 48 full-duplex CDR-based transceiver channels
per device:
■
Thirty-two out of the 48 transceiver channels have dedicated physical coding
sublayer (PCS) and physical medium attachment (PMA) circuitry and support
data rates between 600 Mbps and 8.5 Gbps
The remaining 16 transceiver channels have dedicated PMA-only circuitry and
support data rates between 600 Mbps and 6.5 Gbps
■
1
The actual number of transceiver channels per device varies with device selection. For
more information about the exact transceiver count in each device, refer to
Table 1–1
on page 1–11.
For more information about transceiver architecture, refer to the
Transceiver
Architecture in Stratix IV Devices
chapter.
Figure 1–1
shows a high-level Stratix IV GX chip view.
Figure 1–1. Stratix IV GX Chip View
(1)
General Purpose
I/O and Memory
Interface
Transceiver Transceiver Transceiver Transceiver
Block
Block
Block
Block
PLL
General Purpose
I/O and
High-Speed
LVDS I/O with
DPA and Soft CDR
PCI Express
Hard IP Block
General Purpose
I/O and Memory
Interface
PLL
General Purpose
I/O and
High-Speed
LVDS I/O with
DPA and Soft CDR
PCI Express
Hard IP Block
PCI Express
Hard IP Block
Transceiver Transceiver Transceiver Transceiver
Block
Block
Block
Block
1
PLL
PLL
FPGA Fabric
(Logic Elements, DSP,
Embedded Memory,
Clock Networks)
PLL
PLL
General Purpose
I/O and
High-Speed
LVDS I/O with
DPA and Soft CDR
PCI Express
Hard IP Block
PLL
PLL
General Purpose
I/O and
High-Speed
LVDS I/O with
DPA and Soft CDR
PLL
General Purpose
I/O and Memory
Interface
PLL
General Purpose
I/O and Memory
Interface
PLL
PLL
Transceiver Block
General Purpose I/O and
High-Speed LVDS I/O
with DPA and Soft CDR
600 Mbps-8.5 Gbps CDR-based Transceiver
General Purpose I/O and 150 Mbps-1.6 Gbps
LVDS interface with DPA and Soft-CDR
Note to
Figure 1–1:
(1) Resource counts vary with device selection, package selection, or both.
September 2012
Altera Corporation
Stratix IV Device Handbook
Volume 1
1–4
Chapter 1: Overview for the Stratix IV Device Family
Feature Summary
Stratix IV E Device
Stratix IV E devices provide an excellent solution for applications that do not require
high-speed CDR-based transceivers, but are logic, user I/O, or memory intensive.
Figure 1–2
shows a high-level Stratix IV E chip view.
Figure 1–2. Stratix IV E Chip View
(1)
General Purpose
I/O and Memory PLL
Interface
PLL
General
Purpose
I/O and
High-Speed
LVDS I/O
with DPA
and Soft-CDR
PLL
General Purpose
I/O and Memory
Interface
PLL
General
Purpose
I/O and
High-Speed
LVDS I/O
with DPA
and Soft-CDR
FPGA Fabric
(Logic Elements, DSP,
Embedded Memory,
Clock Networks)
PLL
PLL
General
Purpose
I/O and
High-Speed
LVDS I/O
with DPA
and Soft-CDR
PLL
PLL
General
Purpose
I/O and
High-Speed
LVDS I/O
with DPA
and Soft-CDR
PLL
General Purpose
I/O and Memory PLL
Interface
General Purpose
I/O and Memory
Interface
PLL
PLL
General Purpose I/O and
High-Speed LVDS I/O with DPA
and Soft-CDR
General Purpose I/O and
150 Mbps-1.6 Gbps
LVDS interface with DPA and Soft-CDR
Note to
Figure 1–2:
(1) Resource counts vary with device selection, package selection, or both.
Stratix IV Device Handbook
Volume 1
September 2012 Altera Corporation
Chapter 1: Overview for the Stratix IV Device Family
Feature Summary
1–5
Stratix IV GT Devices
Stratix IV GT devices provide up to 48 CDR-based transceiver channels per device:
■
Thirty-two out of the 48 transceiver channels have dedicated PCS and PMA
circuitry and support data rates between 600 Mbps and 11.3 Gbps
The remaining 16 transceiver channels have dedicated PMA-only circuitry and
support data rates between 600 Mbps and 6.5 Gbps
■
1
The actual number of transceiver channels per device varies with device selection. For
more information about the exact transceiver count in each device, refer to
Table 1–7
on page 1–16.
For more information about Stratix IV GT devices and transceiver architecture, refer
to the
Transceiver Architecture in Stratix IV Devices
chapter.
Figure 1–3
shows a high-level Stratix IV GT chip view.
Figure 1–3. Stratix IV GT Chip View
(1)
1
General Purpose
I/O and Memory
Interface
Transceiver Transceiver
Block
Block
PLL
PLL
General Purpose
I/O and Memory
Interface
PLL
General Purpose
I/O and
High-Speed
LVDS I/O
with
DPA and Soft CDR
PCI Express
Hard IP Block
PCI Express
Hard IP Block
Transceiver Transceiver
Block
Block
Transceiver Transceiver
Block
Block
PLL
General Purpose
I/O and
High-Speed
LVDS I/O
with
DPA and Soft CDR
PCI Express
Hard IP Block
FPGA Fabric
(Logic Elements, DSP,
Embedded Memory,
Clock
Networks)
PLL
PLL
General Purpose
I/O and
High-Speed
LVDS I/O
with
DPA and Soft CDR
PCI Express
Hard IP Block
PLL
PLL
General Purpose
I/O and
High-Speed
LVDS I/O
with
DPA and Soft CDR
Transceiver Transceiver
Block
Block
PLL
General Purpose
I/O and Memory
Interface
PLL
General Purpose
I/O and Memory
Interface
PLL
PLL
Transceiver Block
General Purpose I/O and
High-Speed LVDS I/O
with
DPA and Soft CDR
600 Mbps-11.3 Gbps CDR-based Transceiver
General Purpose I/O and
up
to 1.6 Gbps
LVDS interface
with
DPA and Soft-CDR
Note to
Figure 1–3:
(1) Resource counts vary with device selection, package selection, or both.
I'm new to msp430 and don't have much information. The timer of 51 MCU counts one machine cycle (12 oscillation cycles), so what about the timer of msp430g2553?...
[align=left][b][size=4]1. Solution introduction: [/size][/b][/align][align=left][size=4] For electronic engineers, I believe many people have played with simple temperature and humidity acquisition an...
Most modern PCs no longer have physical COM ports. However, many hardware setups still use UART for logging, diagnostics, and application control. The alternative is to use a USB device that appears a...
/***************************************************************************IAR environment, HD7279A, P4.0~CS, P4.1~CLK, P4.2~DATA, P4,3~KAY,DATA is the serial port data port, the timing diagram is as...
Traditional broadcasting systems generally need to be operated manually at a fixed time, and can only realize one-way broadcasting with few functions. Traditional bell ringing equipment has a singl...[Details]
In
circuit design,
current
measurement
is widely used, and the main fields are divided into three categories: in measurement,
the electric meter
is used to measure the curre...[Details]
1. Circuit composition
The whole circuit consists of two parts:
1. Power saving control circuit
As shown in the figure below. Including delay circuit and drive circuit.
(1) Delay ci...[Details]
At present, the traffic congestion in cities is quite serious. According to relevant news reports: In China, the traffic congestion has expanded from megacities such as Beijing, Shanghai, and Guang...[Details]
1. Introduction
With the growth of parking demand, the scale of parking lots is becoming larger and larger. A lot of research has been done on intelligent parking lots in China, but most of th...[Details]
Do you often have to add brake fluid to your car's brakes? The fact that you need to pump out the brake fluid to make sure there is no gas in the brake fluid line may not be done by the car owner h...[Details]
Converged processors meet scalability requirements
In current embedded system design, solutions based on MCU, DSP, FPGA and ASIC account for more than 90% of the market share. These solutions ...[Details]
This paper designs a dot matrix LED text display screen that is easy to update, expandable, and low-cost. The way to reduce costs is
① Use the Bluetooth data transmission function of mobile ph...[Details]
For a long time, due to the limitation of hardware conditions, the display devices of traditional small handheld devices such as PDA are usually monochrome LCD, and the user interface is very simpl...[Details]
In recent years, lighting has become an important area that countries around the world are targeting to promote energy conservation and environmental protection. According to statistics, about 20% ...[Details]
We know that microcontroller development tools generally include real-time online emulators and programmers. Among them, online emulators are very good tools, but they are also more expensive...[Details]
PV inverter manufacturer SMA has launched its first DC arc fault circuit interrupter (AFCI) PV inverter and has received UL certification.
The new SunnyBoy AFCI inverter models include 3000-US...[Details]
Spatial Division Multiplexing (SDM) MIMO processing can significantly improve spectrum efficiency and thus greatly increase the capacity of wireless communication systems. Spatial Division Multip...[Details]
Abstract: The output of high-range acceleration sensor is less than 10 mV under the excitation of small signal. The noise of traditional test system may cover such small voltage signal, so that hig...[Details]
LED light sources have many environmental advantages, but early products still have certain technical bottlenecks in heat dissipation and high brightness design that cannot be broken through....[Details]
Microcontroller MCU
京公网安备 11010802033920号
EEWORLD
