I would like to ask you experts, from the perspective of electromagnetic compatibility, should the primary and secondary shielding layers of the high-frequency transformer be connected to the input gr...
Especially the position of the "*", why is it not ((GPIO_TypeDef )*GPIOC_BASE) ? ? The original program GPIOC->CRL looks at the definition of GPIOC as follows: #define GPIOC ((GPIO_TypeDef *) GPIOC_BA...
I want to copy an active card. The active card contains an mcu, a nrf24L01 module and a battery. This module sends data at regular intervals. I want to make a nrf24L01 module to receive the data. Is t...
[backcolor=rgb(238, 238, 238)][font=Tahoma, Helvetica, SimSun, sans-serif]Using the routines can't change this situation. It may be that 360 or some software has damaged the files inside, but I don't ...
I want to use ultrasonic wave to avoid obstacles. I use three ultrasonic waves in total - one in front, one in the left and one in the right. The ultrasonic wave module is hc-sr04. The current problem...
In the stvd environment, I compiled the program. The chip I selected was stm8s207cb, and the flash was 128k. The current program obviously does not exceed 128k. Why does this error occur? Is it becaus...
Emergency hand-held lamps powered by 6V maintenance-free batteries are widely used in rural areas. The charger used is a transformer step-down and single diode half-wave rectifier, and the charging...[Details]
1. Introduction
RFID (radio frequency identification) is a non-contact automatic identification technology that emerged in the 1990s. It uses the characteristics of radio frequency signal prop...[Details]
Sailing is gaining more and more attention. How to use modern technology to assist training and improve competition results is particularly important. Considering the real-time data collection in t...[Details]
0 Introduction
With the development of my country's economy, the number of motor vehicles continues to increase. The growth of existing roads and other hardware facilities can no longer meet t...[Details]
Electronic systems are located at different points on the automotive power bus and therefore often need to operate under very stringent power requirements. These include load dump, cold crank, very lo...[Details]
Instrument stepper motor
The stepper motor is an open-loop control element that converts electrical pulse signals into angular displacement or linear displacement. In the case of non...[Details]
1. With the development of modern industry and the continuous improvement of automation, some medium and large control systems have been greatly facilitated, which not only makes control easier, bu...[Details]
1. Introduction to CIF Board
Fieldbus integration based on PC system
Whether it is a master or a slave, fieldbus has won unanimous praise in the field of PC-based automation. For more...[Details]
1. Introduction
Testing the temperature of steel billets before rolling is an important measure to ensure the quality of steel. Traditional manual testing is difficult to ensure product qu...[Details]
The potentiometer is an adjustable electronic component. The main functions of the potentiometer in the circuit are as follows:
1. Used as a voltage divider
A potentiometer is a continuou...[Details]
Only a small number of LED manufacturers can produce high-quality LEDs. For applications that are only used for simple indication, low-quality LEDs are sufficient. However, high-quality LEDs must...[Details]
The rectified DC voltage is then converted back to AC using power electronics such as insulated gate bipolar transistors.
The output voltage is switched on and off at a high frequency, control...[Details]
1. Introduction
With the increasing popularity of fully automatic washing machines, consumers have higher and higher requirements for their environmenta...[Details]
Key Points
1. Now, in addition to high-end smartphones and tablets, users also expect to use touch screens in other applications, and they are gradually appearing in cars and instruments.
...[Details]
1 Introduction to LED
With the development of science and technology, people have higher and higher requirements on automobile light sources. LED (Light Emitting Diode) has gradually attracted...[Details]