Moisture Sensitivity Level (MSL) – This product is Hermetically Sealed and not Moisture
Sensitive - MSL = N/A: Not Applicable
FEATURES:
• 3.2 x 2.5 x 0.9mm miniature package
• Low current consumption 1.5mA for 19.68MHz
• Vc function corresponds to PLL circuits
• Suitable for RoHS reflow profile
APPLICATIONS:
• Cellular and cordless phones
• Standard OSC for exact equipment
• Mobile com munication equipment
• Porta ble radio equipment and music player.
• PLL
STANDARD SPECIFICATIONS:
Parameters
Frequency Range
Standard Frequencies:
Operating Temperature:
Storage Temperature:
Frequency Stability
∆f/f0
vs
Tolerance (@+25°C) at shipping:
Tolerance (@+25°C) after reflow:
Temperature (ref. to +25°C):
Supply Voltage Change (Vdd±5%):
Load Change (ZL±10%):
Supply Voltage (Vdd):
Aging (first year @+25°C):
Supply Current (Icc):
Voltage Control Function
(for ASVTX-11)
Control Voltage (Vcc):
Frequency Tuning Range:
Frequency Tuning Transition:
Input Impedance:
Output
Voltage:
Load:
Waveform:
Phase Noise:
0.8
Minimum
Typical
Maximum
Units
MHz
MHz
°C
°C
ppm
ppm
Notes
10
40
10, 13, 14.4, 16.3676, 19.2, 19.8, 20,
24.5535, 26, 33.6, 38.4, 39, 40
-30
+75
-40
+85
-0.5
-1.5
-2.5
-0.2
-0.2
+3.135
-1.0
+3.3
+0.5
+1.5
+2.5
+0.2
+0.2
+3.465
+1.0
1.5
2.0
2.5
+2.5
See option (Tabel 1)
V
ppm
mA
mA
mA
Vdc
ppm
kΩ
See option
~19.68MHz
~32.00MHz
~40.00MHz
+0.5
±8
Positive
500
+1.5
650
(Left blank if standard)
10k
Ω//10pF
Clipped Sine Wave
-135
Vp-p
dBc
@1kHz
ABRACON IS
ISO9001:2008
CE RTIFIED
CE RTIFIED
Revised: 08.12.14-M
30332 E speranza, Rancho Santa Margarita, California 92688
tel 949-546-8000
|
fax 949-546-800
| www.abracon.com
1
Visit www.abracon.com for Terms & Conditions of Sale
SMD VC/TCXO
ASTX-11, ASVTX-11
OPTIONS & PART IDENTIFICATION:
ESD Sensitive
Pb
RoHS/RoHS II compliant
3 .2 X 2 .5 X 0 .9m m
ASVTX-11 or ASTX-11 -
Vdd (V)
Blank: 3.3V±5%
A: 3.0V±5%
B: 2.8V±5%
C: 2.5V±5%
-
MHz -
-
Packaging
Blank: Bulk
T: 1000pcs/reel
T3: 3000pcs/reel
Frequency in MHz
Please specify the
frequency in MHz.
e.g. 19.200MHz
Table 1: Frequency Stability vs Operating Temperature
±1.5ppm ±2ppm
±2.5ppm
0°C ~ +50°C
D15
D20
D25
-10°C ~ +60°C
E15
E20
E25
-20°C ~ +70°C
F15
F20
F25
-30°C ~ +70°C
G15
G20
G25
-30°C ~ +75°C
H15
H20
Std.(Blank)
-40°C ~ +85°C
I15
I20
I25
±3ppm
D30
E30
F30
G30
H30
I30
±4ppm
D40
E40
F40
G40
H40
I40
±5ppm
D50
E50
F50
G50
H50
I50
OUTLINE DRAWING:
6-pad package (Date Code prior to March 2014):
Note 1: It is not recommended that paths go underneath the
oscillator. If needed, please use multi-layer PCB board or resist
coating.
Note 2: Recommend using an approximately 0.01µF bypass
capacitor between Pin 3 and 6.
Pin
1
2
3
4
5
6
Dimensions: Inches (mm)
ABRACON IS
ISO9001:2008
CE RTIFIED
CE RTIFIED
Function
ASVTX-11
ASTX-11
Vc
GND
N.C.
GND
Output
N.C.
Vdd
Revised: 08.12.14-M
30332 E speranza, Rancho Santa Margarita, California 92688
tel 949-546-8000
|
fax 949-546-800
| www.abracon.com
1
Visit www.abracon.com for Terms & Conditions of Sale
SMD VC/TCXO
ASTX-11, ASVTX-11
OUTLINE DRAWING:
4-pad package (Date Code March 2014 and later):
ESD Sensitive
Pb
RoHS/RoHS II compliant
3 .2 X 2 .5 X 0 .9m m
Due to material availability, 1 or 2 side
pads may appear on the side of the
package The variation in no way
affects the electrical performance of the
product
.
Pin
1
2
3
4
Function
ASVTX-11
ASTX-11
Vc
GND
GND
Output
Vdd
Recommended Land Pattern
1
Note 1: It is not recommended that paths go underneath the oscillator. If needed, please use
multi-layer PCB board or resist coating.
Note 2: Recommend using an approximately 0.01µF bypass capacitor between Pin 2 and 4.
Dimensions: mm
ABRACON IS
ISO9001:2008
CE RTIFIED
CE RTIFIED
Revised: 08.12.14-M
30332 E speranza, Rancho Santa Margarita, California 92688
tel 949-546-8000
|
fax 949-546-800
| www.abracon.com
1
Visit www.abracon.com for Terms & Conditions of Sale
SMD VC/TCXO
ASTX-11, ASVTX-11
REFLOW PROFILE:
ESD Sensitive
Pb
RoHS/RoHS II compliant
3 .2 X 2 .5 X 0 .9m m
TAPE & REEL:
T: 1000pcs/reel
T3: 3000pcs/reel
Dimensions: mm
ATTENTION:
Abracon Corporation’s products are COTS – Commercial-Off-The-Shelf products; suitable for Commercial, Industrial and, where designated, Automotive Applications.
Abracon’s products are not specifically designed for Military, Aviation, Aerospace, Life-dependant Medical applications or any application requiring high reliability where component
failure could result in loss of life and/or property. For applications requiring high reliability and/or presenting an extreme operating environment, written consent and authorization from
Abracon Corporation is required. Please contact Abracon Corporation for more information.
ABRACON IS
ISO9001:2008
CE RTIFIED
CE RTIFIED
Revised: 08.12.14-M
30332 E speranza, Rancho Santa Margarita, California 92688
tel 949-546-8000
|
fax 949-546-800
| www.abracon.com
1
Visit www.abracon.com for Terms & Conditions of Sale
The A/D acquisition card I made is powered by 5V. The +15 and -15 used in the analog circuit are converted by the power module. The switching frequency is 300KHz. After filtering by inductors and capa...
Flip Chip and Surface Mount Process Cell phones, personal digital assistants (PDAs), digital cameras and other consumer electronic products have gradually become smaller, more responsive, and more int...
I used the project in controlSUIT to generate PWM waveforms. It compiled and ran successfully. The registers can also be modified, but why can't the PWM waveform be detected? Is it a problem with my t...
The SPI of PXA310 is used to control MCP2515, and the transmission is normal. After writing the command word to 2515, the chip status register is read. The MISO pin signal is normal when observed by o...
1 Introduction
A wide variety of communication cables and control cables are widely used in various instruments and control equipment. Whether the cable is well-conducted and
whether
th...[Details]
1 Introduction
The high temperature tester is mainly used for temperature tracking measurement and data acquisition during the heating process. By systematically analyzing the test data, the...[Details]
Abstract: In order to generate a stable excitation signal, the design of a digital frequency synthesizer is implemented on FPGA using Verilog hardware language. The design includes accumulator, wav...[Details]
Editor's note: In order to help technicians or engineers who have knowledge of PIC microcontroller assembly language quickly master the method of using C language to program PIC microcontrollers, t...[Details]
AD8205 is
a single-supply high-performance differential
amplifier
launched by
Analog
Devices of the United States
. The typical single-supply voltage is 5V, and its common-mode volta...[Details]
MediaTek (2454) announced the acquisition of F-MStar (3697) and attracted the attention of IC design industry. This morning, Gartner Semiconductor Industry Research Director Hong Cenwei analyzed ...[Details]
With the advocacy and implementation of the government's Safe City Plan, the security market has increasingly higher requirements for the clarity of surveillance images. Imagine that after a case o...[Details]
This controller uses PIC16C54 single-chip microcomputer as the controller, and it is very easy to use: just connect a telephone line to the loudspeaker through the controller, and you can rem...[Details]
Today, with energy becoming increasingly scarce, the utilization of natural energy has become the focus of people's attention. Among various natural energies, the endless solar energy is highly fav...[Details]
Introduction
X1226 has the functions of clock and calendar. The clock relies on hour, minute and second registers to track, and the calendar relies on date, week, month and year registers to tr...[Details]
In order to develop lighting LED technology, developed countries attach great importance to the research of LED testing methods and standards. For example, the National Institute of Standards and T...[Details]
Don’t just look at the power when choosing a power supply
We know that a power supply with a low rated power can hardly meet the power supply needs of the system, which may cause frequent free...[Details]
The overall operating performance of an electric car depends first on its battery system and motor drive system. The drive system of an electric car is generally composed of three main parts: a con...[Details]
1 Introduction
Automatic Test
System The ATS (Automatic Test System) integrates all the stimulus and measurement equipment required for testing.
The computer
efficiently comp...[Details]
Stepper motors, also called steppers, use the principles of electromagnetism to convert electrical energy into mechanical energy and have been used since the 1920s. With the increasing popularity o...[Details]
Analog electronics
京公网安备 11010802033920号
EEWORLD
