audio CODEC (analog-to-digital and digital-to-analog
converter) with single-ended analog voltage input and
output.
Both ADCs and DACs employ delta-sigma modula-
tion with 64X oversampling. The ADCs include a
digital decimation filter and the DACs include an 8X
oversampling digital interpolation filter. The DACs
also include digital attenuation, de-emphasis, infinite
zero detection and soft mute to form a complete
subsystem. The PCM3000/3001 operates with left-
justified, right-justified, I
2
S or DSP data formats.
PCM3000 can be programmed with a 3-wire serial
interface for special features and data formats.
PCM3001 can be pin-programmed for data formats.
Fabricated on a highly advanced CMOS process, the
PCM3000/3001 is suitable for a wide variety of cost-
sensitive consumer applications where good perfor-
mance is required. Applications include sampling key-
boards, digital mixers, mini-disc recorders, hard-disk
recorders, karaoke systems, DSP-based car stereo,
DAT recorders, and video conferencing.
Delta-Sigma
Modulator
Digital
Decimation
Filter
Serial Interface
and
Mode Control
Digital Out
Digital In
Lch Out
Rch Out
Low Pass Filter
and
Output Buffer
Multi-Level
Delta-Sigma
Modulator
Digital
Interpolation
Filter
Mode Control
System Clock
International Airport Industrial Park • Mailing Address: PO Box 11400, Tucson, AZ 85734 • Street Address: 6730 S. Tucson Blvd., Tucson, AZ 85706 • Tel: (520) 746-1111
XTI. (5) Pins 19, 22: DOUT,CLKIO. (6) Pin 21: XTO. (7) Refer to Application Bulletin AB-148 for information relating to operation at lower sampling frequencies.
(8) High Pass Filter disabled (PCM3000 only) to measure DC offset. (9) f
IN
= 1kHz, using Audio Precision System II, rms mode with 20kHz LPF, 400Hz HPF used
for performance calculation. (10) With no load on XTO and CLKIO.
The information provided herein is believed to be reliable; however, BURR-BROWN assumes no responsibility for inaccuracies or omissions. BURR-BROWN assumes no
responsibility for the use of this information, and all use of such information shall be entirely at the user’s own risk. Prices and specifications are subject to change without notice.
No patent rights or licenses to any of the circuits described herein are implied or granted to any third party. BURR-BROWN does not authorize or warrant any BURR-BROWN
product for use in life support devices and/or systems.
NOTES: (1) Models with a slash (/) are available only in Tape and Reel in the quantities indicated (e.g., /2K indicates 2000 devices per reel). Ordering 2000 pieces
of “PCM3000E/2K” will get a single 2000-piece Tape and Reel.
ELECTROSTATIC
DISCHARGE SENSITIVITY
This integrated circuit can be damaged by ESD. Burr-Brown
recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling
and installation procedures can cause damage.
ESD damage can range from subtle performance degrada-
tion to complete device failure. Precision integrated circuits
may be more susceptible to damage because very small
parametric changes could cause the device not to meet its
京公网安备 11010802033920号
EEWORLD
