Probe Technology Primer Personal safety is of utmost importance when measuring electronic systems or circuits. You need to be sure to understand the performance and usage regulations of the measuremen...
After searching for a day and repeatedly comparing with the schematic diagram, I found that the U2 (LDO) on the SensorTile board had no output. This is a 1.8V LDO, which provides basic power to the sy...
dcexpertST Sensors & Low Power Wireless Technology Forum
[i=s] This post was last edited by paulhyde on 2014-9-15 08:58 [/i] D-LC Resonant Amplifier D Question 172697592 Group D-LC Resonant Amplifier D Question 172697592 Group...
I did not design the ID line when designing the hardware. I only need the STM32F107 to work in device mode. How can I force the STM32F107 to work in device mode, that is, to pull up DP after detecting...
I want to use DCO_Library.h and DCO_Library.s43 to generate a standard clock signal through DCO. According to DC0_ Library.h, it can generate a standard 1MHz or 2MHz clock signal. But when I use it, I...
1. Introduction
RFID (radio frequency identification) is a non-contact automatic identification technology that emerged in the 1990s. It uses the characteristics of radio frequency signal prop...[Details]
Sailing is gaining more and more attention. How to use modern technology to assist training and improve competition results is particularly important. Considering the real-time data collection in t...[Details]
The Mobile Industry Processor Interface (MIPI) Alliance is an organization responsible for promoting the standardization of software and hardware in mobile devices. It has released the D-PHY specif...[Details]
Electronic systems are located at different points on the automotive power bus and therefore often need to operate under very stringent power requirements. These include load dump, cold crank, very lo...[Details]
1 Introduction
Ultrasonic waves have strong directivity, slow energy consumption, and can propagate over long distances in a medium, so they are used for distance measurement. Ultrasonic detec...[Details]
1. Introduction
Testing the temperature of steel billets before rolling is an important measure to ensure the quality of steel. Traditional manual testing is difficult to ensure product qu...[Details]
1 Introduction
In recent years, there have been many major advances in the production technology and processes of automotive headlights, which have greatly improved the performance of automoti...[Details]
Smart lighting control systems provide high controllability for various buildings and further enhance the level of green energy. They are the core products of energy conservation and digital techn...[Details]
With the continuous consumption of earth's energy and the scarcity of resources, the harm of greenhouse effect to human beings, and the serious pollution of the atmosphere to the earth, the intern...[Details]
The traditional display screen using 51 single-chip microcomputer to control LED dot matrix has relatively simple functions. If it is to achieve diversified functions, it often takes a lot of time ...[Details]
Different initialization between C8051F and 80C51 series microcontrollers
In the past 30 years, major electronic component manufacturers in the world have launched their own unique single-chip...[Details]
FPGAs are used in 81% of electronic systems, including many commercial and defense products, and most FPGAs use BGA packaging. The BGA packaging is characterized by small solder balls and small sol...[Details]
Almost everyone in a student dormitory has a bedside lamp. But if you want to read for a while after turning off the lights and don't want to disturb your roommates' sleep, you may need a reading l...[Details]
The fluorescent lamps and energy-saving lamps we commonly use now have greatly improved luminous efficiency compared with the earlier ordinary incandescent lamps and have been widely used. With the...[Details]
PCB Design
京公网安备 11010802033920号
EEWORLD
