I use a baud rate of 57600 to receive data information from two CPUs, and use the computer serial port to monitor the data.I found a problem:when the computer is turned on, the serial port (DMA recept...
[i=s]This post was last edited by nnnf on 2019-10-14 16:52[/i]As the title says, I want to use xpctarget to control maxon motor through NI6289 board. The motor is equipped with epos2 driver. xpcTarget...
Can anyone explain how to use the ADC10 of G2553 and its built-in ADC10DTC, including how to get the value (e.g., repeat single-channel mode)? It would be best if there is an example. Thank you......
[i=s] This post was last edited by Xiaoan on 2015-3-6 11:26 [/i] Delete the post. Delete the post. I wrote a program myself. It is actually quite simple....
I would like to ask everyone, the Tamaga servo motor uses a 2048PPR encoder. How many pulses does it send in one revolution? Is it 2048*4=8192? Or 8000? If it is 8192, wouldn't it be very inconvenient...