* See Page 10 for additional developed frequencies.
Check with factory for availability of frequencies not listed.
Description
CTS Model 356P/L is a low cost, high performance PLL voltage controlled oscillator supporting differential LVPECL
or LVDS outputs. Employing the latest IC technology, M356P/L has excellent stability and low phase jitter
performance.
Ordering Information
Model
356
Output
Type
P
Frequency Code
[MHz]
XXX or XXXX
Absolute
Pull Range
B
Frequency
Stability
3
Temperature
Range
I
Supply
Voltage
3
Packaging
T
Code
P
L
Output
LVPECL
LVDS
Code
B
APR
±50ppm
Code Temp. Range
-20°C to +70°C
C
-40°C to +85°C
I
Packing
Code
1k pcs./reel
T
Code
Frequency
Product Frequency Code
1
Code
5
4
3
Stability
±25ppm
2
±30ppm
±50ppm
Code
2
3
Voltage
+2.5Vdc
+3.3Vdc
Notes:
1] Refer to document 016-1454-0, Frequency Code Tables.
3-digits for frequencies <100MHz, 4-digits for frequencies 100MHz or greater.
2] Check factory availability when paired with "I" temperature code.
Not all performance combinations and frequencies may be available.
Contact your local CTS Representative or CTS Customer Service for availability.
This product is specified for use only in standard commercial applications. Supplier disclaims all express and implied warranties and liability in connection with any use of this
product in any non-commercial applications or in any application that may expose the product to conditions that are outside of the tolerances provided in its specification.
Shouldn't the PN532's IRQ pin generate an interrupt when a card is received? I'm using the serial port mode, but why is it that even though I set the IRQ pin to be enabled, it doesn't work? I can read...
This section is the key content of this chapter. In this section, we need to master the formula method and the graphical method to calculate the Q point.Before learning, let's first understand a conce...
I don't know if you have ever encountered garbled characters in UBOOT when converting serial port to USB? I use the sbc2410 board, which works fine on Vivi, but garbled characters appear when starting...
I have been in the industry for more than four years and can use Verilog and C language proficiently; I have two years of experience in FPGA and ARM development; I am familiar with common EDA tools; M...
[i=s]This post was last edited by wsmysyn on 2018-7-29 10:09[/i] As the title: I was debugging FPGA recently and needed to burn the code into Flash; but the jic file was downloaded successfully but th...
I have attached the program for the master to send and the slave to receive. Could you please help me figure out where the problem is? Thanks in advance. SPI_rec_slave (slave receiving program)#includ...