external influences such as PCB construction, circuit
layout etc. As such, external components in addition
to those listed herein may be required in specific
instances to gain full compliance to the standards
specified.
[2]
[3]
Compatible with SurfMate and InMate socketing system
Not intended for socket or Surfmate mounting
M-FIAM9
Page 1 of 7
Rev 3.4
06/2017
vicorpower.com
800 927.9474
M-FIAM9M21
Specifications
(Typical at T
BP
= 25°C, nominal line and 75% load, unless otherwise specified)
INPUT SPECIFICATIONS
Parameter
Input voltage
Inrush limiting
Min
10
Typ
28
Max
36
0.007
Unit
V
DC
A/µF
Notes
Continuous
Intended for use in Military Ground Vehicles where the power
available is per MIL-STD-1275D. Internal capacitance is
~50µF, which precedes the inrush limit circuit. External
precautions should be taken if the source cannot tolerate the
capacitive charge current associated with this
internal capacitance.
Transient immunity
100
250
70
50
V
DC
V
DC
V
DC
V
DC
50ms per MIL-STD-1275A/B/D, continuous operation
70µs per MIL-STD-1275A/B/D, continuous operation
20ms per MIL-STD-704A, continuous operation
12.5ms per MIL-STD-704E/F, continuous operation
OUTPUT SPECIFICATIONS
Parameter
Output power
Output current
Efficiency
Internal voltage drop
External capacitance
330
1000
µF
96
97
0.85
Min
Typ
Max
500
18
1.5
Unit
W
A
%
V
500W, 25°C baseplate
See Figure 7 on page 5
50V
Notes
See Figures 5 & 6
CONTROL PIN SPECIFICATIONS
Parameter
ON/OFF control
Enable (ON)
Disable (OFF)
Min
0.0
3.5
Typ
Max
1.0
5.0
Unit
V
DC
V
DC
Notes
Referenced to – V
OUT
100kΩ internal pull up resistor
SAFETY SPECIFICATIONS
Parameter
Dielectric withstand
Min
1,500
2,121
Typ
Max
Unit
V
RMS
V
DC
Notes
Input/Output to Base
Input/Output to Base
EMI
Standard
MIL-STD-461E
Conducted emissions:
Conducted susceptibility:
Test Procedure
CE101, CE102
CS101, CS114, CS115, CS116
Notes
When using with V28 series converters a 27µH inductor is
needed between the filter and converter for compliance
below 30% of rated power.
EMI performance is subject to a wide variety of external influences such as PCB construction, circuit layout etc. As such, external components in addition
to those listed herein may be required in specific instances to gain full compliance to the standards specified.
M-FIAM9
Page 2 of 7
Rev 3.4
06/2017
vicorpower.com
800 927.9474
M-FIAM9M21
Specifications (Cont.)
GENERAL SPECIFICATIONS
Parameter
Weight
Warranty
Min
Typ
Max
3.3 (94)
2
Unit
Ounces (grams)
Years
Notes
ENVIRONMENTAL QUALIFICATION
Altitude
MIL-STD-810F, Method 500.4, Procedure I & II, 40,000ft. and 70,000ft. Operational.
Explosive Atmosphere
MIL-STD-810F, Method 511.4, Procedure I, Operational.
Vibration
MIL-STD-810F, Method 514.5, Procedure I, Category 14, Sine and Random vibration per Table 514.5C for Helicopter AH-6J Main Rotor with overall level
of 5.6Grms for 4 hours per axis. MIL-STD-810F, Method 514.5C, General Minimum Integrity Curve per Figure 514.5C-17 with overall level of 7.7Grms
for 1 hour per axis.
Shock
MIL-STD-810F, Method 516.5, Procedure I, Functional Shock, 40g. MIL-S-901D, Lightweight Hammer Shock, 3 impacts / axis, 1,3,5 ft.
[i=s]This post was last edited by HonestQiao on 2022-10-2 10:59[/i]This article is long and involves many knowledge points. You need to read it patiently. The following is the directory of specific co...
I'm working on a project recently, 51 control digital tubes, the chip used is MAX7219 cascade mode, 9 cascade drive 69 digital tubes (8 chips drive full 8 bits, one chip only drives 5 bits), there are...
I would like to ask you, the 250W high pressure sodium lamp street light used to have no compensation (power factor was 0.5), the stable current was 3.8A, now after compensation the power factor becom...
Use the CH582 development board as the GATT server to provide data read and write operations. In this way, you can establish a connection with it through a mobile phone and perform read and write oper...
Principles of Operating Systems Tian Lihua, Xi'an Jiaotong University : https://training.eeworld.com.cn/course/5839The course of operating system principles mainly introduces the design methods and im...
[i=s]This post was last edited by paulhyde on 2014-9-15 08:59[/i] [font=仿宋_GB2312][size=3][/size][/font] [font=仿宋_GB2312][size=12pt]Approved by the Higher Education Department of the Ministry of Educa...
1 Introduction
A wide variety of communication cables and control cables are widely used in various instruments and control equipment. Whether the cable is well-conducted and
whether
th...[Details]
1. With the development of modern industry and the continuous improvement of automation, some medium and large control systems have been greatly facilitated, which not only makes control easier, bu...[Details]
1. System Structure
This system is a simulation system of indoor air-conditioning temperature/humidity control system. The data acquisition and control center collects temperature/humidity...[Details]
MediaTek (2454) announced the acquisition of F-MStar (3697) and attracted the attention of IC design industry. This morning, Gartner Semiconductor Industry Research Director Hong Cenwei analyzed ...[Details]
The potentiometer is an adjustable electronic component. The main functions of the potentiometer in the circuit are as follows:
1. Used as a voltage divider
A potentiometer is a continuou...[Details]
Printed circuit boards ( PCBs
)
are used in most electrical products
. If a PCB has low
insulation resistance
(IR), the performance of the circuits on the PCB will be greatly reduced...[Details]
According to the Industrial Technology Research Institute of Taiwan, due to factors such as the oil crisis and global warming, the issues of energy conservation and environmental protection have at...[Details]
Introduction
X1226 has the functions of clock and calendar. The clock relies on hour, minute and second registers to track, and the calendar relies on date, week, month and year registers to tr...[Details]
With the rapid development of cities and the improvement of citizens' living standards, the number of various vehicles in cities is growing, and the demand for parking spaces in major commercial an...[Details]
1 Introduction to LED
With the development of science and technology, people have higher and higher requirements on automobile light sources. LED (Light Emitting Diode) has gradually attracted...[Details]
Against the backdrop of global warming, energy conservation and emission reduction have become a global hotspot and focus, which has also sounded the clarion call for the take-off of the LED lighti...[Details]
A few days ago, I bought an 8LED flashlight in the market (the flashlight uses No. 5 batteries). Because I had other things to do, I didn't pay attention when purchasing it. When I got home and use...[Details]
introduction
At present, the research on micron and nanotechnology is very active, which has led to the rapid development of microtechnology and micro-mechanical electronic system (MEMS) t...[Details]
In order to develop lighting LED technology, developed countries attach great importance to the research of LED testing methods and standards. For example, the National Institute of Standards and T...[Details]
NXP MCU
京公网安备 11010802033920号
EEWORLD
