Training

Location:Training / Maker Show / Arduino / Arduino Basics Video / Extension 5 Arduino74HC595

You can log in to your eeworld account to continue watching：
Extension 5 Arduino74HC595
Login

Duration：11 minutes and 20 seconds
Date：2017/12/02

Uploader：老白菜

Introduction

keywords： Arduino Huijing Electronics

This video explains the installation of Arduino development environment to the basics of digital and electronic C language, explains the use of various sensors and various small DIY designs, and finally talks about the design of smart cars

You Might Like

Recommended Posts

How to send specific data from PC to serial port and then control the operation of single chip?: I came up with an idea to use a temporary array temp to store the value in U0RXBUF, and then call the strcmp function for comparison. But the problem is that temp is an array of uncertain size, so cal; zbnzbnzbnz Microcontroller MCU

How to Eliminate Competitive Risk Taking: module compare(out,a,b);input [7:0] a,b;output out;reg out;always @(a or b)begin if(ab)out=1; elseout=0;endendmoduleWhen performing gate-level simulation, glitches appear in the waveform, which is the; 超自然 FPGA/CPLD

Fully custom ALU module design: Design a 32-bit ALU module using a full-custom method in a 0.13um process, then perform delay analysis and optimization on the circuit diagram based on Hspice; use a modular design method to complete; CauserBait FPGA/CPLD

Why can't the clock interrupt enter?: I am using a jxarm9 2410 board. The experimental environment is ADT. The interrupt request is done and the interrupt enable is done. Normally, the tick interrupt should be automatically triggered once; lnb19850110 Embedded System

【Bee English】20121028: [backcolor=rgb(238, 238, 238)]In order to urge myself to learn English and for the common progress of netizens, I hope to excerpt an English technical article every day and publish it on the forum: [/; ffddybz Talking

A brief discussion on three-phase six-arm full-bridge drive circuit: [i=s] This post was last edited by Li Shilong on 2018-9-27 16:23 [/i] I am a newbie in electric control and have been obsessed with motor control for a few years. From today on, I will give you some t; 李世龙 Motor Drive Control（Motor Control）

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号