Training

Location:Training / Embedded Development / DSP / Signal processing and systems / Fourier analysis of discrete time signals (4)

You can log in to your eeworld account to continue watching：
Fourier analysis of discrete time signals (4)
Login

Duration：33 minutes and 57 seconds
Date：2017/10/09

Uploader：老白菜

Introduction

keywords： Signal Processing Signals and Systems National University of Defense Technology Wu Jing

This course combines the contents of the two courses "Signals and Systems" and "Digital Signal Processing" to provide you with the key to the world of signal processing. Starting here, you will explore the mysteries of signal decomposition with Fourier, and build a bridge between continuous and discrete signals with Nyquist. Teaching resources such as full lecture videos, signal processing cases, answers to exercises, expert lectures, experimental videos, etc. will accompany you to explore the world of signal processing easily and happily.

You Might Like

Recommended Posts

Why do the data read out by my A/D driver always appear the same?: Can you please help me, my A/D driver uses interrupt mode, but the data read out does not change, why?#include#include#include#include#include/* printk() */ #include/* kmalloc() */#include/* everythin; yzy8212 Embedded System

Can you tell me about the cost of your initial learning of microcontrollers?: There are often tutorials on how to learn microcontrollers in ten days circulating on the Internet, and there are also various development boards widely distributed. [b]Please list your expenses and e; clark MCU

Impedance matching: The article introduces input impedance, output impedance and impedance matching; linjingui Analog electronics

2013 Summer Life Tips: Summer is a season full of vitality, and it is also a season to pay special attention to physical health. The hot summer is closely linked to the busy production. Sweating and loss of appetite are cha; 绿茶 Talking

Motor drive: This is my circuit diagram. When the third voltmeter is connected to the motor, the display is less than 1. When it is not connected, it displays 11V. Why is this? In the actual circuit, the voltage a; 清风飘过 Analog electronics

Serial port garbled code problem: My MCU program and host computer program run normally on the development board. The host computer uses VB, the MCU uses 51, the baud rate is 9600, and the development board crystal oscillator is 11.05; qqwweerr Embedded System

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号