Training

Location:Training / Embedded Development / DSP / Signal processing and systems / Experiment 2 Sampling Theorem and Signal Recovery (2)

You can log in to your eeworld account to continue watching：
Experiment 2 Sampling Theorem and Signal Recovery (2)
Login

Duration：11 minutes and 47 seconds
Date：2017/10/09

Uploader：老白菜

Introduction

keywords： Signal Processing Signals and Systems National University of Defense Technology Wu Jing

This course combines the contents of the two courses "Signals and Systems" and "Digital Signal Processing" to provide you with the key to the world of signal processing. Starting here, you will explore the mysteries of signal decomposition with Fourier, and build a bridge between continuous and discrete signals with Nyquist. Teaching resources such as full lecture videos, signal processing cases, answers to exercises, expert lectures, experimental videos, etc. will accompany you to explore the world of signal processing easily and happily.

You Might Like

Recommended Posts

Strong 51 MCU knowledge is essential for the competition: [i=s] This post was last edited by paulhyde on 2014-9-15 09:24 [/i] Strong 51 MCU knowledge is required for the competition; woshishiyanshj Electronics Design Contest

I want to compare data inside FPGA and output the maximum value, but there is a problem during simulation. I hope you can answer this question!: Let me first tell you my idea: I want to continuously send 8-bit data to the FPGA, and then send out the previous largest data (so I need to keep comparing) when a certain IO port is at a high level.; HDU_Kingso FPGA/CPLD

HT46R47 controls multi-point temperature acquisition system: For those who do scientific research, this can be said to be the most classic example.; rain Industrial Control Electronics

How to measure the power of high-current and high-capacity lithium batteries?: The current demand is to accurately measure the power of large-capacity and high-current lithium batteries. Do you have any chip recommendations? The equipment is used on drones.; sunnyicecream Analogue and Mixed Signal

Key interrupt adjusts PWM pulse duty cycle to adjust LED brightness: I am a beginner in MSP430. When I came into contact with TA, I wrote a program according to the example that can use the key interrupt to adjust the PWM pulse duty cycle to adjust the LED brightness.; jin1991 Microcontroller MCU

I encountered this knowledge point when debugging the code and I would like to share it with you. It may be very low-level knowledge.: [b]Excerpt from the expert's answer blog[/b][b][url=http://quanminchaoren.iteye.com/blog/1870977]The difference between #if, #ifdef, and #if defined[/url][/b][list] [b]Blog Category:[/b] [*][url=http:; WZH70246 MEMS sensors

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号