Training

Location:Training / Circuit Fundamentals / Digital / Digital circuit and system design / Karnaugh map composition and representation - Karnaugh map composition

You can log in to your eeworld account to continue watching：
Karnaugh map composition and representation - Karnaugh map composition
Login

Duration：11 minutes and 54 seconds
Date：2018/07/01

Uploader：老白菜

Introduction

keywords： Timing analysis digital Combinational Circuits logic circuit

The course content mainly includes: basic knowledge of digital circuits (number system, coding, logic algebra, logic gates, flip-flops, etc.), combinational circuit analysis and design methods, sequential circuit analysis and design methods, pulse waveform generation and shaping, programmable logic devices and analog-to-digital conversion, etc.

You Might Like

Recommended Posts

Help post: About IR2110 driver problem: [i=s]This post was last edited by paulhyde on 2014-9-15 03:48[/i] I recently built a IR2110 driver circuit. When I used an oscilloscope to look at the low-end output, the waveform was a normal square; DairyQ Electronics Design Contest

Application of LM324 quad op amp.pdf: [i=s] This post was last edited by paulhyde on 2014-9-15 09:28 [/i] It is very useful in the competition~~~; 贺增甫 Electronics Design Contest

Final version of BeagleBone peripheral circuit design: [size=5]I worked hard last night and finally finished the PCB. [/size] [size=5]The system block diagram is as follows: [/size][size=5]PCB front: [/size][size=5]PCB back: [/size]; chenzhufly DSP and ARM Processors

DeviceIoControl communicates with the USB hardware: Using DeviceIoControl() to communicate with the USB flash drive, the communication mode is IOCTL_SCSI_PASS_THROUGH_DIRECT. Here, a CDB command block is required. How do I get this CDB command? I saw a; xi19871208 Embedded System

The process of WEBENCH design + the design process of solar street lights using webench: Project requirements: solar street light. Brightness: 650lm; Power supply: lithium iron phosphate battery, supply voltage 12V or 24V. Working environment: normal temperature Demand analysis: The solar; azhiking Analogue and Mixed Signal

Why can't I debug rd, tf, etc. in the output in MiniIDE?: I can't type rd in miniIDE to register the output, and I can't press enter.; godblessyou Embedded System

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号