• Duration:46 minutes and 29 seconds
  • Date:2018/07/05
  • Uploader:老白菜
Introduction
keywords: tcp ip
TCP/IP protocol is the abbreviation of Transmission Control Protocol/Internet Protocol. The Chinese translation is Transmission Control Protocol/Internet Protocol, also known as network communication protocol. It is the most basic protocol of the Internet and the basis of the Internet international network. It is composed of IP at the network layer. The protocol and transport layer are composed of the TCP protocol.
TCP/IP defines standards for how electronic devices connect to the Internet and how data is transferred between them. The protocol adopts a 4-layer hierarchical structure, and each layer calls the protocol provided by the next layer to complete its own needs. In layman's terms: TCP is responsible for discovering transmission problems, sending a signal when there is a problem, and requiring retransmission until all data is safely and correctly transmitted to the destination. IP assigns an address to every networking device on the Internet.
Unfold ↓

You Might Like

Recommended Posts

Solution to the problem of not receiving a single data packet in time when the serial port baud rate is changed to 9600 in CC2530
When debugging CC2530, it is found that when the baud rate is changed to 9600, the receiving DMA will start when a single packet has only 3 bytes.Therefore, the data packet is forced to be split into
wateras1 RF/Wirelessly
Is there any good IC you can recommend?
I often connect PNP/NPN transistors into push-pull output to drive high-power loads. Is there any IC that only needs digital output and does not need analog output ? Please recommend it.
display8989 Analog electronics
I don't know how to delete a post
[i=s]This post was last edited by Takazzz on 2017-10-10 14:04[/i] :time:
Takazzz stm32/stm8
Can signaltap be set to automatically trigger after power-on? I encounter abnormal counting after power-on.
The debug script reads out that a register is 1 after power-on. This section of code is generated by a for loop. The initial values of the other registers are normal and there is no problem with the t
qan FPGA/CPLD
Is the effect of dynamic loading of max541 driver different from that of integrating into NK?
max541 is a 16-bit DA chip. The wince driver written for this chip is integrated into NK and dynamically loaded with different effects. 1. After integration into NK, I found that max541 outputted 1.8V
Rain_ning Embedded System
Pre-register to watch the live broadcast and get gifts: TI processor theme month is in full swing, three live broadcasts will set off a blast in August this year!
[size=3]Three live broadcasts full of dry goods will burn the whole month of August! So much content can't be missed! {:1_107:} [b][color=Red]Live broadcast details: [/color][/b]>> [b][url=https://www
EEWORLD社区 TI Technology Forum

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号