• You can log in to your eeworld account to continue watching:
  • Solving the frequency domain characteristics of dynamic circuits
  • Login
  • Duration:8 minutes and 21 seconds
  • Date:2020/05/01
  • Uploader:木犯001号
Introduction
keywords: amplifier CMOS MOS
Analog Circuit Basics: From System Level to Circuit Level" closely focuses on the theme of weak signal processing circuits and organizes content from system level to circuit level. The system-level circuit teaching goal is ECG signal processing circuit design, and the circuit-level circuit teaching goal is Single-ended output two-stage operational amplifier circuit design. The course closely combines simulation experiments with theoretical teaching, organically integrating the theoretical foundation and related skills necessary for modern analog circuit engineers.
Unfold ↓

You Might Like

Recommended Posts

ISO 26262 Fault Tolerance Time Interval
I would like to share with you another important concept in functional safety - Fault Tolerant Time Interval (FTTI).Fault Tolerant Time Interval is a core concept in ISO 26262, and can also be called
Aguilera Microcontroller MCU
Regarding the calculation of filter capacitor, I urgently need an explanation~~~
I have posted a picture below. I don’t understand the formula (2.12) in the picture. I can’t find any relevant explanation. Can any expert explain it to me?
xcyseh Power technology
How to use ROMS instructions in CCS
I was reading the documentation of VC5509A recently. I can run programs with an emulator, but I can't write programs into it, so I was reading the content of Hex Conversion Utility. I can call Hex Con
dontium DSP and ARM Processors
W806 Lianshengde 9.9 yuan development board experience 5 --- demo completed experience end
SPI-DMA has been added, and the speed is faster than before. The playability is still quite high even with a lower resolution. There is enough ROM and RAM space. However, the SDK peripheral drivers ne
RCSN Domestic Chip Exchange
File filter driver binding problem.
To bind a file, you must first bind the device object and then bind the volume to read and write. However, in the sfilter that comes with DDK, after binding the device, it will determine whether WINVE
weisheihuozhe Embedded System
I have a question about the RJ11 interface
How do you represent RJ11 in PROTEL's sch? There are 11 pins in a circuit diagram, but there are only 6 pins in the PCB package.
天天雨 Embedded System

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号