datasheet

Training

Location:Training / Maker Show / Raspberry Pi / British Raspberry Pi Getting Started Tutorial / British Raspberry Pi Getting Started Tutorial (4): Using the GPIO Port (Part 1)

  • You can log in to your eeworld account to continue watching：
  • British Raspberry Pi Getting Started Tutorial (4): Using the GPIO Port (Part 1)
  • Login
Chapters
  • Duration：11 minutes and 22 seconds
  • Date：2015/08/07
  • Uploader：chenyy
Introduction
keywords： Maker raspberry pie
British Raspberry Pi getting started tutorial, from easy to difficult, based on hands-on practice, teaches you how to play with Raspberry Pi.
Unfold ↓

You Might Like

Recommended Posts

Encoder counting principle and motor speed measurement principle - multi-picture analysis
[i=s]This post was last edited by DDZZ669 on 2021-2-14 23:30[/i] Encoder is a sensor used to measure mechanical rotation or displacement. It can measure information such as the displacement position o
DDZZ669 Motor Drive Control（Motor Control）
Why are USB oscilloscopes unreliable?
USB-based oscilloscopes have been around for so many years, but there has been little development. Is it because they are small, unprofitable and have no future for development?
飞鸿浩劫 Creative Market
Cadence PCB Free Online Training (August-October)
2012 Cadence PCB 16.5 Special Online Training (August-October) ———— Hosted by: Cadence Agent - Ketong Group In 2010, Ketong became the largest value-added agent of Cadence in China. Ketong is also the
njust_wu PCB Design
LED backlight's primary goal in 2010: reducing costs
[b]Opportunities and Challenges: [/b][list][*]LED backlight in 2010 aims to reduce costs[/list]Market data: [list][*][b]Manufacturers are trying to replace the current mainstream 3020 low-power specif
樱雅月 LED Zone
Has anyone used SAM4L8? I have a question.
There is a touch button on the SAM4L8 board. After adding the touch button module to the project in ASF, the touch button does not respond. However, after adding the serial port module, the button res
beian10 Microchip MCU
Comparison of the appearance and heat generation of two Anker chargers
[i]Foreword: I bought a charger for my colleague a while ago. Her phone is Android, so I wanted it to support QC3.0 and be good to use (the key is to look good...). After choosing, I chose an Anker ch
tianshuihu Power technology

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号