• You can log in to your eeworld account to continue watching:
  • Process Control Systems (continued)
  • Login
  • Duration:45 minutes and 47 seconds
  • Date:2021/05/28
  • Uploader:木犯001号
Introduction
keywords: electronic electrician
The rapid development of modern control and digital technology has made advanced electrical control and information systems an important technical support for almost all non-electrical engineering fields. Future non-electrical engineers who are eager to understand the application points and basic technologies of electrical information systems should take this course! She will lead everyone to share the joy of building an overall knowledge framework for electrical information systems, and reap the joy of the experimental process of "perceptual cognition" and "I design and implement it."

Unfold ↓

You Might Like

Recommended Posts

win ce5.0, how to make a Chinese version of the kernel?
I made a kernel with PB5.0, but it shows the English version. When I customized it, I selected international->chinese and also selected setting->local->Chinese. But the Chinese version of the kernel i
seaskywd Embedded System
【Design Tools】ChipScope Pro User Guide ---- Attached code and test waveforms
This article introduces how to use ChipScope Prothrough a specific example , gives the whole code , and ModelSim simulation results. I have tried this example and can get the desired results, so I rec
GONGHCU FPGA/CPLD
533MHz Processor S3C2443 Wiring Guide
The same applies to S3C2450. The BGA spacing of S3C2443 is 0.5mm, which is much higher than the 0.8mm of S3C2410 and S3C2440, and requires a much higher PCB process, and blind holes need to be made.
gina MCU
How can I give the following circuit a signal source for simulation?
The passband signal frequency obtained after filtering by the above circuit is required to be around 60KHZ. How to simulate the signal source (the software I use is multisim)? Could you please explain
州平卞 Analog electronics
What is 5v tolerance?
Can a 5V tolerant pin be connected directly to a 5V power supply without damage? Can a non-5V tolerant pin be connected to a 5V power supply with a resistor in series (using its internal clamp protect
kjxxbjb stm32/stm8
【TI recommended course】Recommendation #Consumer Electronics Application and Design Seminar#
//training.eeworld.com.cn/TI/show/course/5540
lukouGao TI Technology Forum

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号