I use the ADC of msp430G2553 to directly sample the output value of the dual power supply circuit. The dual power supply circuit outputs a sine wave with a bias of 0 through an amplifier. I use the AD
When debugging STM32, the lower right corner of keil mdk t1 will show the execution time of each function. As shown in the figure: t1 will count the time and you can see it. At this time, software sim
[i=s] This post was last edited by jameswangsynnex on 2015-3-3 19:58 [/i] 1 What standard does HCMOS refer to, and what is the difference between it and HCMOS? 2 What unit is LS-TTL? ? 3 In a crystal
Friday, July 28, 2006 20:46:13Experiment on the effective value method of power consumption measurement Measure test for RMS method of power lossAbstract: This paper derives the calculation formula fo
[i=s]This post was last edited by yl20084784 on 2014-10-27 17:34[/i] [size=4]I've been debugging the serial port 1 of an MSP430 recently. Sometimes it can send and receive normally, but it stops worki
[i=s] This post was last edited by dontium on 2015-1-23 11:35 [/i] Based on the characteristics of LDC1000, a vehicle detection test board was made. The processor used is STM32F103, and the SPI read a