SPI experiment-ICM20608 actual measurement value calculation and opening of 6ULL hardware floating point

You can log in to your eeworld account to continue watching：
SPI experiment-ICM20608 actual measurement value calculation and opening of 6ULL hardware floating point
Login

Duration：28 minutes and 32 seconds
Date：2023/04/22

Uploader：EE大学堂

Introduction

keywords： ARM Punctual Atom IMX6U

This course is an introduction to ARM bare metal in the series of courses that Punctual Atomic teaches you step-by-step on how to learn Linux. The accompanying development board for this course is the Punctual Atomic alpha/mini Linux development board.

Unfold ↓

Recommended Posts

ARM storage space: I read in a book: ARM system uses a single and flat address space. The address space size is 2^32 8-bit bytes, and the unit address of these bytes is an unsigned 32-bit value, whose value range is 0~2; 31551075motoe2 ARM Technology

The F2812 FLASH was successfully burned, but a strange warning prevented the program from running.: My F2812 simulation is normal. Erase/Program/Verify Operation succeeded when burning FLASH, but this warning appears. As a result, the program does not run: "Warning: This program contains initialized; netthief Microcontroller MCU

Google is leaving again~~~~~~~~~~: [size=3]According to current information analysis, Google is very likely to withdraw from China and the negotiations between the two sides have failed. British media reported that the possibility of G; open82977352 Talking

Some questions about Samsung cortex A9 4412 uboot startup: Recently, I found that some iNand/TF boot methods of 4412 and S5PV210 are somewhat different. Some disk indexes of 4412 are not fixed on a certain channel, while S5PV210 is fixed. This causes some peo; Wince.Android Embedded System

eboot compilation problem: ] Stop. BUILD: [00:000000058:INFO ] Relinking \WINCE500\PLATFORM\SMDK2410\SRC\BOOTLOADER\EBOOT\ because target lib: E:\wince500\platform\smdk2410\target\ARMV4Ietail\eboot.exe does not exist. BUILD: [0; ctwolf_ren Embedded System

Discuss the feasibility of tty drivers for devices connected to serial ports: The device connected to the serial port is an infrared receiver module. Because the driver's workflow is: handle_scancode-->|tty_queue|-->|tty_ldisc|-->/dev/ttyX and the communication protocol of the; wangs168 Embedded System

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

Training

Location:Training / Embedded Development / ARM / ARM(IMX6U) bare metal article / SPI experiment-ICM20608 actual measurement value calculation and opening of 6ULL ​​hardware floating point

Recommended Content

Hot VideosMore

Hot ArticlesMore

Location:Training / Embedded Development / ARM / ARM(IMX6U) bare metal article / SPI experiment-ICM20608 actual measurement value calculation and opening of 6ULL hardware floating point