[i=s]This post was last edited by paulhyde on 2014-9-15 03:48[/i] I recently built a IR2110 driver circuit. When I used an oscilloscope to look at the low-end output, the waveform was a normal square
[size=5]I worked hard last night and finally finished the PCB. [/size] [size=5]The system block diagram is as follows: [/size][size=5]PCB front: [/size][size=5]PCB back: [/size]
Using DeviceIoControl() to communicate with the USB flash drive, the communication mode is IOCTL_SCSI_PASS_THROUGH_DIRECT. Here, a CDB command block is required. How do I get this CDB command? I saw a
My question is: when is this RXNE set to 1, is it set to 1 when a bit of data is transferred to USART_DR, or when a frame of data is completely transferred?
There are two cases for the two's complement representation of a number: (1) The two's complement of a positive number: the same as the original code. (2) The two's complement of a negative number: th
Electronics Design Contest
京公网安备 11010802033920号
