ghaytweyhtoo

FSICEBASE: FSICE Base Station

Overview

The NXP^® Semiconductors in-circuit emulator (FSICE) consists of a base station and a MCU emulator module (EM). Connected to a target system, the FSICE replicates the actual target system MCU and provides a full-featured emulator system for developing embedded systems using HC(9)08 microcontrollers.

The FISCEBASE station controls interaction between the MCU emulator module and the PC.

MoreCollapse

Documentation

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-05-27 22:03:22

Can tantalum capacitors replace aluminum electrolytic capacitors?
As shown in the circuit diagram, the electrolytic capacitors C13, C11, C15, and C16 in the power supply part were all tantalum capacitors at the beginning. There is a very strange phenomenon, that is,
Can't generate .cod file after setting environment variable WINCECOD?
I have set the environment variables in the BAT configuration file: set WINCEMAP=1 set WINCECOD=1 After compilation, the corresponding .map and .cod files should be generated. However, the .map file c
evc serial port programming serial port debugging tool ask the expert
I am writing an evc serial port program for serial communication between arm and dsp. But I have encountered a problem in writing and debugging. This is the serial port receiving thread in the program
[Trf7960 question] How to modulate the 13.56M antenna to match 50Ohm?
I use TRF7960 to read and write M1 cards. The circuit part refers to the evaluation board of Lm3s9b96. The antenna part on my board has output 13.56M sine wave. Now I can read and write registers (0x0
Newbie, ask about ARM's B instruction
In the assembly language, there is BL FUN and then there is a B. What does this "B." do? I have read several books on ARM instructions but none of them explain it clearly. Please give me some advice.
Looking for entrepreneurial partners in the industrial control industry (only in Shenzhen)
Our company is engaged in wireless communication. We have a formal office building of more than 90 square meters in Luohu District. It is located in the center of the city with convenient transportati

Datasheet More

Circuits More