JFET

AC current measurement system based on STM32 (program, circuit information)

Overview

The overall structure of this design is roughly composed of a main control module, a current signal sampling module, a power module and a serial port output module. In this article, the main control chip uses a microcontroller model STM32F103RC, which makes the structure as small as possible while ensuring the current sampling accuracy. It is as simple as possible, avoids complex and changeable circuit layout, is more convenient for PCB board production, and is relatively low-cost. Among them, in the design of the sampling conditioning circuit, a current transformer is used to sample the current signal.

Design Files

Source code, schematic diagram

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-05 20:03:18

Balancing ADC Size, Power, Resolution, and Bandwidth for Precision Data Acquisition Systems
[i=s]This post was last edited by qwqwqw2088 on 2021-12-24 08:41[/i]The trend toward smaller industrial products is creating new challenges for precision data acquisition systems. Designers must balan
Can ultrasound detect the net?
[i=s]This post was last edited by paulhyde on 2014-9-15 03:31[/i] I really don’t know if ultrasound can detect the grid around the four axes because I don’t have the materials. . . I read in the liter
Please help me look at my problem, thank you
The error is as follows:undefined first referencedsymbol in file--------- ----------------FS$$MPY C:\\ti\\myprojects\\cputimer2\\Debug\\DSP28_CpuTimers.obj FS$$TOUL C:\\ti\\myprojects\\cputimer2\\Debu
Please help me find where the program went wrong and how to fix it!
#include#include#include #define uchar unsigned char #define uint unsigned int uchar code dis_code[10]={0xc0,0xf9,0xa4,0xb0,// 0, 1, 2, 3 0x99,0x92,0x82,0xf8,0x80,0x90};// 4, 5, 6, 7, 8, 9, off uchar
Using CD4046 for modulation and demodulation, the circuit and parameters are as follows. However, the demodulated wave is half wave.
C1=1000P, R1=10K determines the center frequency. R3=160 ohm, C2=0.1U in the low-pass filter. Pins 3 and 4 are short-circuited, which may not be clearly drawn in the diagram. Now input a signal of abo
MSP430G2 development board touch sensor daughter card learning experience
After reading all the information about MSP430G2, I was hesitant. In the end, I took the initiative to test my beloved 430 and experimented with the touch sensing daughter card. I removed the capacito

Datasheet More

Circuits More