石榴姐

OCP to PCIex4, x8

Overview

OCP network card to PCIE

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-05-08 17:59:30

About CAN interrupt of 8962
I would like to ask you. After my program enters the CAN interrupt, I use CANIntStatus (CAN0_BASE, CANI_INT_STS_CAUSE) to read, but why does it always return "0"? I have read a lot of documents, and d
TM4C123G cannot simulate TI routine timers. . .
[url] I am a beginner in M4 and want to create a new program by imitating the source program. I found that after setting various paths and predefined symbols, the compilation can pass, but the functio
Transfer some new idle development boards, all of them are brand new
[i=s] This post was last edited by fesns on 2014-9-9 20:10 [/i]I am transferring some unused development boards on behalf of a friend. They are all brand new. [b] Transfer a brand new STM32F030R8 DISC
Seek advice from experts
This is the main control diagram of the circuit of my board. It has been simulated with proteus. There is no problem with the circuit measurement when soldering the circuit, but there is no response w
What is the status of the STM32 pin after setting it to push-pull output?
I have a question!After the STM32 pin is reset, it is in high impedance input state. Then I configure the pin as push-pull output.But it does not assign a valueof 0 or 1. Does it output 0 or 1 at this
SensorTile.boxr's personal experience
I just received my engineer's certificate. It took me two years to pass the exam and I finally got it after retaking it .Let’s get to the point It has been more than half a month since I received it.

Datasheet More

Circuits More